All motors require electrical conductors in their rotor!
A parallel plate capacitor is an electrical component which can store charge. The charge is stored according to the equation: qo = q(1-e-t/RC) [in a charginr circuit.]
Theoretically, Capacitance is defined as the ability of a component or circuit to collect and store energy in the form of an electrical charge. Mathematically, it is defined as the ratio of the change in an electric charge in a system to the corresponding change in its electric potential.
Fuse's are used to limit electrical current to a "safe" level within an electrical appliance. Since the fuse has blown it indicates that something as happened within the television which is causing it to draw an excessive amount of electrical current. The most likely cause is that a component has failed in a "shorted" state. Identifying the specific component will require some experience in electronic troubleshooting.
A "Rectifier" is an electrical component that changes AC current to DC current by blocking current in one direction. High power rectifiers may be "assembled" from multiple individual component rectifiers to handle higher power or larger voltages.
Mica is a key component in electrical equipment. In the years 2006-2007 India exported 15.21 million US dollars worth of mica, and that number has been steadily growing.
A cold circuit
The router.
What component of ied creates electrical charge
electrical component, mechanical component, functional component and procedural component
the answer is: magnetic...magnetic and electrical
No. An inductor by definition is a passive component that stores electrical energy in an magnetic field. It does not use real power (in any serious amount). A synchronous motor is not passive, and uses real power.
Load
A capacitor
Electrical Component(s)
Conductors pull heat away from the component you are protecting from heat created from current flow. Keeping it safe from over heating and damaging itself.
By definition an electrical circuit is a route or path that starts and finishes at the same place. So there is no part of an electrical circuit that is not necessary, because if there were it would not be an electrical circuit.An electrical circuit needs a power source. Conductors to transmit the voltage from the power source to the load. The final component of the electrical circuit is the load that you want to energize.If you remove any of the components there will be an open circuit and the load will be impossible to operate.
That's called a speaker.