answersLogoWhite

0

Its kind of a toss up as to what wheels will fit a mark vii although we have 5 stud hubs and axles the problem lies in the front hub and bearing. Most new model fords SN-95 or newer have the hub machined at a 45 degree angle. The problem with most wheels is that the hub sticks to far out without being machined. The second problem is that if you find wheels that fit or machine the hub the center ca[s for the wheels most likely wont fit because of the endcap for the bearing assembly. Machining the rotors are not that difficult i did it in my drive way with a 5 in die grinder. I have 99-04 mustang bullitt wheels on my mark. good luck

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Will Honda rims with a 4x100 pattern bolt onto a 96 VW golf?

factory Honda wheels won't fit. the center hole is too small.


Can You Put On skateboarding bearing on to wheels then put wheels on trecks?

you mean trucks and yes you can but the easier way is to put a bearing onto a truck then push the wheels onto the bearing


What is wheel for?

Wheels are for fitting tires onto.


Can an Oldsmobile turbo 350 bolt onto a sbc350 motor?

Not usually. Most of the transmissions that have the Oldsmobile bolt pattern do not have the Chevrolet bolt pattern.


Where does the exhaust bolt on to a scooter?

Onto the exhaust port of the engine...


Will a th400 transmission bolt onto a gm 305 small block?

as long as it is a chevy bolt pattern th400


Will a 350 bolt onto the stock 5spd in a 1991 firebird with the 3.1 v6?

No the bolt pattern for the v6 and the v8 are different


Can you put smaller wheels on a Honda xr 100?

Not sure on other years, but the XR80 and XR100 1985/86/87 used the same frame. The XR100 had the same diameter forks, but 50mm longer than the 80, and the swingarm was 50mm longer also, but the wheels were interchangable, IE: the XR80 wheels would bolt straight onto the XR100. The XR80 had 14 inch rear and 16 inch front wheels, the XR100 had 16 inch rear and 18 inch front. HTH


Can a 5x130 bolt pattern rim fit onto the 07'CLS550?

No, it cannot. Mercedes Benz uses a 5x112 bolt pattern.


How can I effectively remove a rounded allen bolt?

To effectively remove a rounded allen bolt, you can try using a rubber band or a specialized tool called a bolt extractor. Place the rubber band over the bolt and use the allen key to grip onto the rubber band, then turn it counterclockwise. If that doesn't work, use a bolt extractor to grip onto the rounded edges of the bolt and turn it counterclockwise to remove it.


What is a creative way to display Hot Wheels cars?

maybe photograph all your hot wheels and then upload them onto a hot wheels collector site on the web. whatever you decide to do keep collecting.


How can a bolt with no head be removed?

To remove a bolt with no head, you can use a pair of locking pliers or a screw extractor tool to grip onto the bolt and twist it counterclockwise to loosen and remove it.