All of the current would travel down the remaining intact wire - possibly overheating.
Nothing much will happen except the same bulb will not blow..
Any gap in a series circuit causes the whole thing to stop working. That is why houses are wired in parallel with each other, and indeed there are many parallel circuits inside each house.
It wil be on
Parallel circuits are used when there are many electronics on the same circuit, such as Christmas lights, for example. If they were on a series circuit, if one bulb went out all of them would go out. In your home, parallel circuits allow you to turn any electrical device on or off, independently of the others.
The question is ambiguous, however one possibility is a parallel circuit, which would permit one light bulb to remain lit while the other light bulb was switched off. By contrast, if the light bulbs were connected in a series circuit, switching one light bulb off would cause both lights to go off.
There will be no change, because it is a parallel circuit.
Nothing much will happen except the same bulb will not blow..
If one wire was to break only one of the bulbs on the circuit would stop working whereas if one wire broke on a series circuit all the bulbs would stop working.
A parallel circuit
In a parallel circuit nothing would happen. All the other light bulbs would remain on since there is an alternative path for current to flow. In a series circuit the entire circuit would be de-energized and all the bulbs would go out.
Yes, but then it would be a 'series-parallel' circuit, not a 'parallel' circuit!
A lighting circuit would be a parallel circuit.
parallel circuit
A parallel circuit
No, series parallel, as it implies has components of the circuit configured in both series and parallel. This is typically done to achieve a desired resistance in the circuit. A parallel circuit is a circuit that only has the components hooked in parallel, which would result in a lower total resistance in the circuit than if the components were hooked up in a series parallel configuration.
A series/parallel circuit.
The parallel-tuned filter in antenna circuit rejects only the undesired frequencies.