0
What else can I help you with?
Where is the back-up light switch on a 91 Honda Civic 1.5 automatic?
the back up light switch is located in the gear shifter console
Why would the speedometer odometer and cruise control on a 1998 Honda Accord stop working and is it difficult to fix?
Sounds like the speed sensor on the transmision, or the conector on same. It could also be an under dash fuse. I am not familar with the accord but my civic speed sensor fuse is shared with about four other sensors and the voltage regulator. Hope that helps.
Why don't the tail lightswork on a 1985 Honda Accord if the brake lights and the back up and the turn signals work and the fuse is not blown?
There should be a switch located on the shaft that the brake pedal is attached to. Check the wiring and listen for a click when the brake is depressed. If everything seems okay, use a wire to jump across the two contacts and see if the brake lights go on. If this fails, then you have a broken wire somewhere in your brake light circuit. Good luck.
SRS light was on in 2001 Honda Civic Dealer checked said seat belt tensioner needed to be replaced awaiting part Light seems to be working fine since what does this part do and is SRS still working?
There is a sensor in the belt buckle assembly that communicates with the SRS system. If that sensor goes bad it trips the SRS light. If this light is illuminated while driving it is safe to assume that your airbags will NOT deploy if you were to get into an accident. Be careful!
What was Honda's advertising slogan for the Super Cub motorcycle?
"You meet the nicest people on a Honda"
Where is the wiring for the speed sensor located on your 1998 Honda Civic EX transmission?
It is located directly above the transmission. There is a detachable wire harness.
Where is the speed sensor in a 93 Honda delsol?
It is located on the top of the transmission, you can access it without removing the transmission as it is connected to the engine wiring harness.
How do you replace oxygen sensor in Honda civic?
The oxygen sensor on a Honda Civic is replaced by disconnecting the wiring harness and removing the sensor using a socket wrench. Anti-seize paste is applied to the threads, a new sensor is torqued into place, and the wires reconnected.
Where is a crankshaft sensor 1999 Honda passport 6 cylinder?
Crankshaft sensor on Honda/Isuzu 3.2l V6 is located on the lower passenger side engine block . If you look through the wheel well at the block just behind the motor mount you will see the wiring harness plug going in.
Where is the iat sensor located in a 93 Honda prelude?
The IAT sensor on the 1993 Honda Prelude is located to the right of the intake manifold as you face the engine compartment. It is connected with red and green wiring.
How do you replace o2 sensor Honda element?
To replace the O2 sensor in a Honda Element, first, ensure the engine is cool and disconnect the negative battery terminal. Locate the O2 sensor, usually found on the exhaust manifold or the catalytic converter, and unplug the wiring harness. Use a wrench or O2 sensor socket to unscrew the old sensor, then install the new one by threading it in and tightening it securely. Finally, reconnect the wiring harness and the battery terminal.
How to replace Honda Ridgeline knock sensor?
To replace the knock sensor on a Honda Ridgeline, first disconnect the negative battery terminal to ensure safety. Locate the knock sensor, typically found on the engine block, and remove any components obstructing access. Unplug the wiring harness from the sensor, unscrew it using the appropriate socket, and replace it with the new sensor. Reconnect the wiring harness, reassemble any removed parts, and finally reconnect the battery.
Where is the heater oxygen sensor bank 1 sensor 1 located on a 1999 Honda civic dx 1.6L?
The bank 1 sensor is located front and center on your engine. It looks somewhat like a spark plug. It has 3 wires leading into it from a wiring harness located about 12 inches to the left of the sensor. It is at the top,front of the engine,partially covered by your exhaust shroud.
How do you replace the VSS on a 93 Honda Del Sol and where is it located?
The VSS is located on the top of the transmission and is connected to the engine wiring harness. To replace it all you need to do is unplug the old one from the wiring harness and unscrew it from the transmission, instalation is the reverse of removal.
How to Replacing oil pressure sensor 92 Honda Accord?
The oil pressure sensor on a 92 Honda Accord is replaced by disconnecting the wiring harness and unscrewing it using a wrench or socket set. The replacement sensor is then put into place and torqued back to specs.
Where is the location of the O2 sensor for 1997 Honda Accord EX. 4Cyn?
if you have the F22B1 (97EX 2.2lVTEC) engine , the front 02 sensor is located below the exhaust manifold on the front of the engine, it has a wiring harness attached to it, and is screwed into the exhaust pipe from the top, before the Catalytic converter. the rear O2 sensor is located AFTER the catalytic converter, and is attached similarly.
Will a stereo from a 1999 Honda Fit in to a 1995 Honda?
The wiring harness from the 1999 stereo has a 21 prong plug and the 1995 has a 14 prong plug you can purshase a harness from Honda but it has to be hadrwired to the exsisting wiring but don't screw it up, go to Honda and get a wiring diagram for the both of them to match up the wiring you need to make it work.
