You may purchase an inexpensive cheese slicer wire at Royal Kitchenware in Houstin, Texas. The store is located at 9333 Harwin Drive, Houston, TX 77036-1815.
The red wire is the positive wire. The black wire is the ground wire. The green and yellow wires are the speaker wires. The white wire is the auxiliary wire.
It's dependent on the wire's composition. That is, what material it is made of. <<>> The electrical resistance in a wire depends on the wire's length and cross sectional area.
1996 Ford Thunderbird Car Stereo Radio Wiring DiagramRadio Constant 12V+ Wire: Black/OrangeRadio Ignition Switched 12V+ Wire: Yellow/BlackRadio Ground Wire: Black/Light GreenRadio Illumination Dimmer Wire: Light GreenRadio Antenna Trigger Wire: N/ARadio Amplifier Trigger Wire: Dark BlueFront Speakers Size: 5″ x 7″Front Speakers Location: DoorsLeft Front Speaker Wire (+): Orange/Light GreenLeft Front Speaker Wire (-): Light Blue/WhiteRight Front Speaker Wire (+): White/GreenRight Front Speaker Wire (-): Green/OrangeRear Speakers Size: 5″ x 7″Rear Speakers Location: Side PanelsLeft Rear Speaker Wire (+): Gray/Light BlueLeft Rear Speaker Wire (-): Tan/YellowRight Rear Speaker Wire (+): Orange/RedRight Rear Speaker Wire (-): Brown/Pink
Connect the sub woofer to the equalizer or amplifier. The positive wire will need to be connected to a power source. Connect the ground wire. Connect the auxiliary wire to the amplifier.
On an Ford automatic transmission it should be located on the transmission where the gear shift linkage connects. There is normally a 4 wire connector on it.
as you look at the throttle body (from the front of the vehicle) it is on the right side opposite the throtle linkage just under where the air tube from the air filter clamps to the throttle body. it has a two wire connector. yellow wire with a black tracer and a grey wire with a red tracer.
The throttle body does not operate by linkage or cable. It operates by wire (electronic).
Could be the linkage. If the wire link stretches over time, it will need periodic adjustment.
To wire the ignition for a 1966 Dodge Coronet, first ensure you have the correct wiring harness and ignition switch. Connect the battery positive terminal to the ignition switch, and then run a wire from the ignition switch to the ignition coil's positive terminal. The negative terminal of the coil should be connected to the distributor. Lastly, make sure the starter solenoid is properly wired to ensure the engine can crank when the ignition is turned on.
The flux linkage formula used to calculate the total magnetic flux passing through a coil of wire is given by the equation N, where represents the magnetic flux, N is the number of turns in the coil, and is the magnetic flux per turn.
the vss wire is located as the purple/white wire above the radio, the harness plugging into the clock. tap into the purple/white wire for your aftermarket headunit vss wire.
there is no wire it is controlled by a sensor.
That wire is your kick down connection. It should be connected to a switch either on the carb or the gas peddle linkage. Applying 12 volts to that wire will activate the kick down mode.
its on the top of the transmission just look and have a friend shift the gears and look for the shifter linkage its connected to the neutral safety switch just disconnect the shifter linkage and unplug the wire harness and take the screws off The Haynes manual has a fair picture of the switch and it's location.
I used the hole where the shift linkage runs, directly in front of the shifter.
You mean the brake wire? Which one?