if the source is switched off there will be leakage slowly discharging the capacitor
When a capacitor discharges the discharge current flows in the opposite direction to the current used to charge it.
Capacitor contains a dielectric sandwitched between two plates. So, it act as a charge storage device. When dc supply is given,it gets charged to its maximum capacity or potential equal to the supply, and then it act as a open circuit, since it has no way to discharge.
in the capacitor they have constant voltage wen supply is given the capacitor get charged(high voltage)and discharge energy wen the voltage is low below the applied voltag.
A capacitor is a storage device like a battery it will however discharge at a rate of 63% for one RC time constant .so it is there to provide more initial force.
when we replace the resistor with a capacitor ,the current will flow until the capacitor charge when capacitor will fully charged there is no current through the circuit because now capacitor will act like an open circuit. for more info plz E-mailt me at "zaib.zafar@yahoo.com"
Obtain a disposable camera, Slip on a pair of rubber gloves, Open the case, Locate the large electrolytic capacitor on the PCB, Discharge the flash capacitor safely, Discharge the flash and remove the battery,Wind the film up until it clicks and stops, Click the shutter button, Locate the charge switch on the front of the PCB, Feeling adventurous, Attach the coil to the switch,Charge your EMP and lastly Fire when ready.
The capacitor can discharge over the connecting wires; i.e., outside the capacitor. Some discharge can also occur over the dielectric, since it will not insulate completely.
I think you over-laod and blow the capacitor
Nope
For part of the AC voltage wave, the capacitor will be above the source voltage, and will discharge until the AC voltage wave increases above the capacitor's stored voltage.
No, because as soon as a load is connected across a capacitor it will discharge. You need a continuous voltage supply across the coil of a relay to keep it energized. Yes. A large capacitor, 10000 mfd, can hold open a small relay for a few seconds, plus or minus, depending on your varibles.
Capacitor discharge ignition
Capacitor discharge ignition
When a capacitor is powered off in an energized circuit, the capacitor still stores a certain amount of electricity. When there are other loads or components in the circuit, they will slowly discharge, or they can be quickly discharged by short-circuiting with small resistors or wires (at low voltage). When the capacitor discharges, the two poles of the capacitor respectively carry a certain amount of charge, and the outside world and the capacitor form a closed loop (generally, the closed loop does not include a power supply). The excess electrons (negative charges) approach the positive electrode of the capacitor to form a current, so that the charges at both ends of the capacitor are neutralized. When the neutralization is completed, the electric field between the two electrodes of the capacitor disappears. However, this is in an ideal situation. The amount of terminal charge is exponentially neutralized towards zero, but not zero. Discharge requirements of capacitors After the capacitor is disconnected from the bus, it must be discharged through a discharge resistor or a special voltage transformer. Discharge should be performed between the lead wires of the capacitor and between the lead wires and the casing. The capacitor can be grounded after the capacitor is discharged. Before working on the capacitor, be sure to conduct a test discharge. This discharge is to place the discharge rod on the terminal of the lead wire of the capacitor for a period of time. Even if both sides of the capacitor device are grounded, in order to prevent residual charge on the capacitor, a test discharge must be performed, and each group of capacitors connected in parallel must be discharged. Special care should be taken when conducting inspection discharge of capacitors removed due to faults. Due to the damaged capacitor, the general grounding device may not function as a ground discharge due to a partial disconnection. If the capacitor device has an interlock device, it should be considered that only after the entire device is grounded, the small door of the capacitor bank protective fence can be opened. We're JYH HSU(JEC) Electronics Ltd (or Dongguan Zhixu Electronic Co., Ltd.), an electronic components manufacturer. You may google "JYH HSU" to find our website.
Stick a screwdriver between the 2 wires. This discharges the capacitor
If the resistance is in series with the capacitor, the charge/discharge time is extended.
When a capacitor discharges the discharge current flows in the opposite direction to the current used to charge it.