answersLogoWhite

0


Best Answer

the master cly is located under the fresh air intake box ,you have to remove the cabin air filter box on the driver side under the hood

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Adding brake fluid reserve tank on a 2006 BMW 525?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the brake fluid reservoir in a 2006 jetta?

where is the brake fluid reservoir on a 2006 jetta


How do you put fluid in the clutch of a 2006 ford escape?

On a 2006 Ford Escape : The brake fluid reservoir is also the clutch fluid reservoir


Where is the brake fluid reservoir for a 2006 BMW 530i located?

no


What type of brake fluid is required for a 2006 Passat?

dot 4


Can you use transmission fluid instead of brake fluid in a 2006 Chrysler Pacifica?

NO! Don't even think about it!


What kind of brake fluid do i use for 2006 Nissan Pathfinder?

dot 3


What is the best brake fluid for a 2006 dodge stratus?

Dot 3 or Dot 4


What kind of brake fluid do you use for a 2006 dodge caravan?

Dot 3 or Dot 4


What type of brake fluid does a 2006 ford free star use?

Ford specifies a high quality DOT 3 fluid. Do not put any other fluid in the brake system as it will cause damage and may make the brakes inoperative.


Where is the brake fluid resovoir located in a 2006 Chrysler Town and Country mini van?

The brake fluid reservoir is under the hood on the driver side. It is the yellow cap back near the base of the windshield.


How do you add brake fluid to a Honda CR-V?

Find the brake fluid reservoir, on a 2006 it is in the back of the engine compartment on the driver's side (upper right corner). Open the reservoir, add new fluid to the max line and replace the lid.


Why does the park brake light come on in a 2006 dodge ram?

The red brake light comes on when the p brake is set, the switch for the p brake is faulty, the brake fluid level is low, or the brake fluid level switch is faulty. If the abs light is also on, you will have codes in the abs computer too for an electrical failure of a sensor or switch..