answersLogoWhite

0


Best Answer

Sure you can, if it's comfortable and it looks good, go fer it!!!you will probably want a short stem on it so it dont wallow back and forth.....Hope this helps.....TatuBaron

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can you really wear labret studs in your helix piercing?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Music & Radio

Is Rihanna not virgan?

you would have to ask Rihanna. Because you know that most guys will lie about anyone to make themselves look like studs


Does sound go through acoustic panels?

Yes. Acoustic panels are meant to reduce echoing, not stop sound for passing through. To stop sound from passing through, you need 1 of 3 things: 1. A wall that is heavy. conrete block walls are good for this. You can also use double layers of gypsum wallboard on each side of the wall. 2. Offset wall studs. Your side of the wall is on one set of studs, and the other side of the wall is on an entirely different set of studs. This way, there is no direct path for sound waves to pass through. 3. Mount the wallboard on both sides of the wall on spring clips. The spring clips prevent a direct transfer of sound through hard materials.


What is the name and origin of the bracelet Freddie Mercury wore on his arm during the Live Aid concert?

The armband Freddie wears is a 3/4 inch wide black latigo leather band with 1/2 inch pyramid studs and 5/8 inch snaps. Items like this are typically sold at stores like Hot Topic. Or you can make them by buying the leather from a craft store and cutting it to size. The snaps can also be purchased at a craft store like Michaels or JoAnn Fabrics. You will need a leather hold punch to apply them along witha hammer. The studs can be purchased at specialty shops online.


How do you Replace starter on 1997 Grand Cherokee?

try this.this is how it works on my 98 jgc. hope it helps Disconnect your battery, then remove the two nuts from the starter wire harness. Pull the wire and cable of the studs. Remove starter bolts and slide starter out of bellhosing.


Should you get your cartilage pierced with a gun or needle?

Needle. Guns are bad news. They can't be completely sterilized. Which means that if theres any dirt, dust, or blood in there, it can't be cleaned completely. It also uses a lot of force to shove a blunt stud through your ear. This causes unnecessary trauma to your ear and can even shatter cartilage. Guns can also malfunction easily. Studs can get stuck in the gun or even break. People who use guns aren't pros. They just read a short manual on how to use the gun. They don't require any knowledge of basic anatomy, blood-borne pathogens, or basic sterilization practices that the pros are required to learn. Definitely go to a professional piercer. APP certification is best but not all good piercers are APP certified. Just be sure that wherever you go , they use an autoclave to sterilize everything.

Related questions

Where can you buy labret studs from in the UK?

At any piercing parlor.


What jewelry is used in a conch piercing?

Anything really. Usually either rings, labret(lip) posts, or straight barbells. Rings are worn in ones that are close to the edge/helix portion of your ear. Studs and barbells are usually worn in low conchs or ones that are far in the center. But you can wear whatever.


Can you wear a nose stud in a monroe piercing?

Yes, labret studs are fine for tragus piercings. I wear them all of the time.


Where can you find lip aka labret studs that from the outside look like a sparkle?

They are called Bio-Plast labret studs, they are a bio-compatable plastic labret stud. www.wildcat.co.uk


What types of jewelry can be used in a tragus piercing for example eyebrow bar tongue bar labret stud can you use these?

Labret studs and any kind of ring are best. You could use an eyebrow bar if you'd like but it can look a bit strange because the ball would point down. Tongue bars are way too long. You could use smaller barbells though, they work just as well as labret studs. Just not the same variety :)


Do side lip piercings ruin teeth?

Yes and No, yeah that's clear as mud huh? Here's the skinny. It really depends on the jewellery that's in the piercings and the placement of the piercing. Obviously rings will be played with and this will wear on the tooth enamel leading to dental damage. If the piercings are done with labret studs or micro labret studs and placed correctly and stepped down to shorter ones once the swelling has eased. The chances of dental damage are greatly reduced due to location and proper sizing. That's the facts, based on over 17 years of experience providing professional body piercing services.


Is plastic studs ok for monroe piercing?

If it's well healed and you can find a proper labret type stud made of plastic, then sure. It would potentially save your teeth if you were to ever bite down on it for whatever reason certainly.


Why is the jewelry for your marlyn monroe piercing sinking into the inside of your lip?

Because you should have been given two labret studs one for day time (shorter) and one for night time (longer) to prevent the recession into the upper lip.


If you get snakebites with labretes can you change them to rings?

Of course! You're originally pierced with labret studs to accommodate the swelling and to ensure that the piercing will stay straight, but after the initial healing time (6-8 weeks) you can change them to rings if you'd like. :)


What is the art of applying studs called?

Hole piercing


What are bioplast labret studs?

They're studs made out of flexible plastic. The ends are usually metal and are pushed into the post instead of screwed in. The plastic is a lot easier on your gums/enamel but they can wear down quickly.


Which nose ring is suitable for your nose?

This depends entirely on anatomy, the angle of the piercing, and personal choice. Some people like circular barbells, captive bear rings, or nostril hoops. Some people like nose bones, and labret style studs. Some others are just fine with the basic nostril screw. It's up to you, find what you like and what works for your piercing and stick with it.