Pop hood. There is a torx head visible from the top at the edge of the fender--believe its like a T-20 or T-25. The second one is a bit more difficult---gonna have to slide the torx head screwdriver between the marker (side) lens and the turn signal at the front of the vehicle. There is another torx screw, same size, in there. once removed, just pull out the lens. Install is reverse.
If just the headlight, unplug and remove the light bulb in the back and may have to remove a screw or two. Then get a good grip on the lens and pull and it should pop right off. To put it back on, you should be able pop it with your hand 1 or 2 times, then just replace the screws if you had to remove any and plug the bulb back in.
Undo the hex nut on top of the headlight assembly and remove bolt. Grap bottom front of headlight assemby and pull hard upwards causing the bottom pins to release then pull directly outwards to release the top pins. Turn back of globe anti clockwise to release globe from headlight assembly.
WJJEEPS.COM has a good write up on this but the short answer is the is a bolt that holds the headlight housing that you remove then gently pull the housing forward until it pop out of the clips.
How do I change a headlight bulb on a 1998 jeep grand cherokee?
in order to change a side marker lamp on a jeep grand cherokee, you must remove the actual headlamp via the bolts on top and the one underneath... fairly easily accesible. then there is one bolt on the top side ot the marker lamp and one from behind that can only be accesible after the headlamp is removed, sounds harder then it actually is, take the headlight out and it will be foolproof from there
How do you change the orifice tube on 1997 grand Cherokee jeep with 5.2 v/8
Did you ever find out how to change the headlight assembly? If so, please let me know how to do it :)
how to change the headlight lens on a grangcherokee jeep
My headlight is not working on the passengers side. Do I need to change out the headlight assembly or can I simply change out the bulb? My headlight is not working on the passengers side. Do I need to change out the headlight assembly or can I simply change out the bulb?
Begin by removing the wiring harness from the back of your 1990 Ford Mustang headlight assembly. Remove the headlight assembly retaining bolts. Reverse the process to install your new headlight assembly.
Begin by removing the wiring harness from the back of 2004 Volvo headlight. Remove the headlight assembly retaining bolts. Reverse the process to install your new headlight assembly.
are you trying to change the entire headlight assembly? or just the bulb.
Gen 1 or 2? With the drivers side you will have to remove the battery and then the nuts to the lights, disconnect the wiring and remove.
The horn is located behind the drivers headlight. To remove unplug harness, undo bolt in bumper assembly behind drivers headlight (must be removed first), and it slides out. To install new, follow steps in reverse.
The headlight assembly (aka the headlight bucket) is removable by releasing the lock tabs behind the assembly. Once the assembly is wiggled out in the open you can easily replace the bulbs.
you will probably have to take the complete headlight assembly out to get enough room to change the bulb.
Open the hood and then examine the top of the headlight assembly and locate the two pins that can be pulled up and out of the assembly. Then rotate the headlight Assembly out of the front of the grille and change the headlight bulb...reverse the process
To change the headlight assembly just loosen/remove the two bolts holding the entire light assembly in (side marker, headlight and turn signal)Also remove the screw located where the marker light and headlight meet. Once these are removed the entire assembly will shift to the right for the drivers side (when facing the vehicle) or to the left for the passenger side (when facing the vehicle). Once the assembly is removed you will have access to the wires/bulb. To ressemble simply do the reverse. hope this helps. "G"