A very common problem is the oxygen sensor wires are shorting out on your drive shaft. Crawl under the Jeep and look to see if your wires are rubbed bare from the drive shaft . tape the bare wires and resecure away from the driveline. this sensor shares the fuel pump/asd relay fuse...
One
i have a 97 grand Cherokee and discovered in 2002 that there was a recall on rollover switch to cut off fuel might be a place to start
It doesn't have one. The fuel system is computer controlled using relays.
The fuel pump is in the fuel tank. The tank has to be removed to access. The pump is computer controlled with relays.
The 1996 Jeep Cherokee headlight relay switch can be found on the firewall in the engine compartment. The headlight relay switch will be on the drivers side of the firewall.
The fan motor and relays do go bad.
One
A 1988 Jeep Cherokee does not have an inertia switch. The fuel system is computer controlled with relays.
The relay for the power antenna on a 95 jeep grand Cherokee is located inside the glove box. You have to remove a panel that is in the "floor" of the glove box and there are several relays in there. There are 6 small relays and 6 large relays, the antenna relay is the top left large relay.
its probably hunted its probably hunted
the relays are on the side on the drivers side beside the dash.
If the fuse keeps blowing then there is a short somewhere in the wiring. The best thing to do is recheck the wiring on the wiper motor, switches, and relays.
It doesn't have one. The fuel system is computer controlled with relays.
hey i have a 1992 Cherokee the relay is on the right side of the steering wheel behind the lower panel there are three relays there its the middle one i think
Jeep doesn't use fuel cutoff switches. The fuel system is computer controlled by relays.
Jeep does not use inertia./reset switches. The fuel system is computer controlled with relays.
blower relay located on the engine compartment by the firewall