i have a 96 Dodge ram van 2500. I lift the hood up and right above the 2 adjusting screws that adjust the beam, or better yet, ontop of the head light lens you will see 2 clips ( they lock those 2 adjusting screws in place) and are actually holding your head light assembly in place. Pull those clips up, dont pull them out, just enough to release those 2 screws that are holding you lens assembly in place.....good luck
Pry the climate control panel off. Pull the instrument trim ring off. This will allow you to see all the screws that secure that portion of the dash. Remove the radio and all the screw in that area. Remove glove box and the screws in that opening. The screws along the top of the dash are obvious.
can anyone tell me how to replace the dash lights in my 2003 Toyota tacoma prerunner sr5?
Remove the instrument panel decorative cover. All of the light bulbs will be visible. Take hold of the lightbulb, push in and turn at the same time. The lightbulb will come out.
i have Jeep grand cheroke 2008 since the check engine light is on and i don't have any problem when i drive the car but how i reset this light (chek engine ligt on) with thank's
This matters if a 1500, 2500, or 3500...
The rear seat releases are typically in the trunk under the speakers. Just give the knobs a pull and the seatback should release. If the middle seat belt is in the way, there is a release for the lower part on the assembly that if you insert a key it should come out and pull up out of the way.
there are for screws that hold it on. Two on the ash tray. and two on the cup holders then there are two holding the radio in.
The answer is simple - You can't fix it! I had the very same problem in the very same vehicle. I also had a Dodge Intrepid with the same exact problem. The evaporator has to be replaced. I dodge dealer will chare you about $850.00 The dash has to be completely removed. This problem seems to be too common with Dodge vehicles. I bought my last Dodge product in 2001 (Grand Carrivan) I will no longer by any Dodge vehicles. Good Luck!
go back an see what u did step buy step
You have to remove some screws and then pull the headlight assembly out of its place. it is held in with a clip after all the screws are removed.
Remove the headlight assembly to gain access to the bulbs.
I have a 2005 1500 and you have to pull the whole assembly out. There is a bolt that is really hard to get to on the bottom!
1. Take the three bolts that hold the headlight/ blinker lens assembly off. 2. Pull kind of hard straight out. There is a clip that should release. If it does not realease then break it. 3. Change bulb.
9004
Open the hood and on the top of the headlight assembly there should be two pins. Turn them so they face the front of the truck and pull them up and out. Now you should be able to pull the whole headlight assembly out. Turn the ring on the back of the headlight ,unplug it and pull the headlight out. Install in reverse order.
Yes but the gears have to be changed
http://www.coolbulbs.com/HID-VISUAL-HEADLIGHT-AIMING-PROCEDURE.pdf
The headlight have adjustment levelers on the top and bottom of each headlight. Adjust the headlight up or down with the adjustment levelers.
2001 - 1999 9004/hb1
the hole dash has to come out . just change mine in a 02 dodge ram 1500.
No, there is not a diagram for the rear brake assembly for a 1995 Dodge Ram 1500 online. The diagram can be found in its maintenance manual bought at auto part stores.