The O2 sensor is located on the exhaust, most Cherokee's have 2 exhaust banks, so there should be one on each side of the engine. Find a wrench to fit it and screw it out, there should be an electrical connection running to it so find where it connects and disconnect it. Reverse for installation.
I had that same exact problem with a 1995 Jeep Cherokee, and it was indeed a bad oxygen sensor. Relatively cheap repair too.
There is no afs on a cherokee, they run on a map sensor.
There is no such sensor, the oil change reminder only runs off of mileage on a 2004
Check the oxygen sensor. My 1995 Grand Cherokee stopped stalling while driving after it was replaced.
The heated oxygen sensor, or O2 sensor is located at the exhaust system before the catalytic converter. Removal & Installation # Raise the vehicle and support it with jackstands. # Disengage the O2 sensor wiring connector and remove it using tool YA 8875, or its equivalent. # Inspect the threads of the new O2 sensor. Apply an anti-seize compound only if there is none visible on the threads. Be careful not to contaminate the sensor tip with any foreign compounds. # Install the sensor using tool YA 8875, or its equivalent and engage the wiring connector.
How do you change oxygen sensor on a 2006 Chevy aveo?"
In the exhaust pipe, near the engine.
How do you change oxygen sensor in 1992 Toyota corolla? Is there a model engine 4A-FE without a oxygen sensor?
I had that same exact problem with a 1995 Jeep Cherokee, and it was indeed a bad oxygen sensor. Relatively cheap repair too.
"how do you change a throttle position sensor on a 1998 jeep grand Cherokee?" could someone without any experience do it?
Please answer the question. "How do you change an oxygen sensor in a 2002 Pontiac Bonneville
OEM stands for original equipment manufacturer. The Oxygen sensor senses amounts of oxygen in the exuast to adjust the fuel mixture acordingly.
Remove the oxygen sensor vacuum to. Remove the oxygen sensor screws. Reverse the process to install the new oxygen sensor.
# The sensor is located in the exhaust manifold or exhaust pipe and is accessible from under the vehicle # Since the oxygen sensor may be difficult to remove with the engine cold begin by operating the engine until it has warmed to atleast 120 degrees # Disconnect the electrical wire from the oxygen sensor and carefully unscrew the oxygen sensor from the exhaust pipe.Be adviced that excessive force may damage the threads inspect the oxygen sensor for damage unless you are replacing it
# The sensor is located in the exhaust manifold or exhaust pipe and is accessible from under the vehicle # Since the oxygen sensor may be difficult to remove with the engine cold begin by operating the engine until it has warmed to atleast 120 degrees # Disconnect the electrical wire from the oxygen sensor and carefully unscrew the oxygen sensor from the exhaust pipe.Be adviced that excessive force may damage the threads inspect the oxygen sensor for damage unless you are replacing it
To replace the oxygen sensor on a 1995 Jeep Grand Cherokee, first, ensure the engine is cool and disconnect the negative battery terminal. Locate the oxygen sensor, typically found on the exhaust pipe or manifold; use a wrench or oxygen sensor socket to unscrew it. Install the new sensor by threading it in and securing it, then reconnect the wiring harness and the battery terminal. Finally, start the engine to check for proper function and any warning lights.
It is called an oxygen sensor socket.