answersLogoWhite

0

You will need to obtain a "pickup" device that mounts to the lower part (below the bridge) of the strings. When connected to an amp, that device then acts much like a microphone and transmits those sounds into amplified sounds. Otherwise you will have to use a microphone to amplify it. You can also buy pickups for accoustic Guitars that fit in the sound hole.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Can you connect Guitar Hero 2 with Guitar Hero 3?

no


How do you use guitar hero world tour guitar controller on playstation 2?

First turn the guitar on and then connect it to the wireless receiver


What are the best 2 input guitar amps available on the market?

Two highly regarded input guitar amps on the market are the Fender Blues Junior IV and the Marshall DSL40CR. These amps are known for their quality sound, versatility, and reliability, making them popular choices among guitarists.


Who makes couplers to connect 2 v8 engines together?

couplers to connect 2 enging together for sale


How can I connect 2 guitars into 1 amp for a dual guitar setup?

You can connect 2 guitars to 1 amp for a dual guitar setup by using a guitar splitter or an A/B switch pedal. These devices allow you to plug both guitars into the same amp and switch between them easily.


Search Results: how do you connect 2 computers together with patch cords not a hub?

You would use cross-wired cables to connect 2 computers together.


How do you get 4 ampere from 2 volt power supply?

if you connect a 0.5 ohm load to it, the power supply will try to push 4 amps through it. but 4 amps@ 2 volts is quite a lot, and it may not succeed.


Can you connect 2 amps to run a subwoofer?

If your sub is 2 ohms and your amp is 2 ohm stable, your done. Your amp will be at 2 ohms because the sub is 2 ohms.


Can you connect 12-2 wire to 14-2 wire together?

You cannot connect 12-2 wire and 14-2 wire together. This can be dangerous, and it will cause issues with the circuit.


200ma in amps?

200ma is .200 amps or .2 amps


List all components needed to connect 2 computers together?

All the components needed to connect 2 computers together are two Ethernet cards, a network switch and 2 Ethernet cables. Alternatively a single USB transfer cable can be used for simple file transfers.


How sli work?

Connect the cards to the motherboard and use the jumper which came with the motherboard to connect the 2 cards together ,and there you go!