answersLogoWhite

0


Best Answer

Wire it to a power source that also cuts off when you turn the cars ignition off, like the signal lamps or something else.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you get the aftermarket radio to cut off with the car?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Do you need a special harness for 2005 Chevy cavalier aftermarket radio?

Yes, you can get one at "Wal-Mart" or a store like "Best Buy". Dont cut the plug off the car!


Why does my Car radio turn off and on?

If your radio will not shut off when you turn off the car, there may be an issue with the wiring. If your car has the feature where your radio will not turn off until you open the door, that is normal. However, if you have an aftermarket radio, the wiring is most likely the cause.


How do you run an amplifier off a normal car radio?

Normal car radio is no different than aftermarket. Determine the output wires on the radio, take them into the amp and the output from the amp back to the wires going to the speakers. Normal car speakers are not going to take the output of the amp if you raise it much.


Where is the cut off switch for 87 celebrity?

There is no factory cut off switch, but aftermarket devices are often installed near the fuse panel.


What is wrong with a car radio when it will not cut off when the car is off?

If it has recently been wired in it has probibly not been wired in correctly. There are normally two power points for a car radio, one constant and another that works only when the ignition is on. By the sounds of it, it is wired into the constant power source, hence not switching off with the ignition.


How do you wire a aftermarket stereo in a 1996 Ford Explorer Sport if factory speaker wire harness has been cut off?

See "Related Questions" and "Related Links" below for radio wiring diagrams.


Can the radio with the security system be replaced with aftermarket radio's in a 2000 Bonneville SE?

You can replace the radio in a 2000 Bonneville with an aftermarket radio; however, the cost for the kits to make it work plus the labor could be cost prohibitive. The Bonneville's radio is connected to the computer. In fact if you replace the radio with an OEM, you still need to take the car to a dealership to have the new radio programmed. On top of that other electronic systems run through the radio wiring. Unless there is a very compelling reason, you would be better off to keep the factory equipment.


How do you repair a theft system device that enables the car to crank at times on a 98 Chevy Malibu?

I know that if you have an aftermarket radio it will make it go off. the stock radio goes through the computer. you have to run a separate constant and acc power to your radio. or if you have a draw on the power to the fusebox in the engine compartment. .


Why when you turn off and on again your car you loose the radio channels ant the hours of the clock?

Its because your 12v memory wire, usually yellow on aftermarket stereos, isn't holding 12 volts, which you need to find an alternate wire that is 12 volts with the key on or off and u can usually find this in the fuse box, this usually happens when u connect the yellow and red wires together when installing an aftermarket radio


How do you cut dome light off on 1999 wrangler?

Take out the fuse or replace door switch with aftermarket


How to Unlock car stereo for a 1997 chey cavalier with tape deck only?

only the dealership can unlock the radio,and they charge more than its worth,better off getting an aftermarket stereo and having it installed!


How do you keep your Toyota Camry radio and clock for resetting when you cut your car on and off?

You can't. Unless you figure out how to connect both of the to an external power supply.