You need to go to a sound shop and buy an adapter that will allow your radio to be plugged into the car's wiring harness. You will also need to ask them which ground wire to cut, so you don't blow out the dimmer switch for your dash lights.
There is many reason, check fuse,check amplifier and check head unit. Otherwise install an aftermarket radio probably the best thing to do. Pretty simple follow this link http://www.installdr.com/Harnesses/Toyota-Wiring.pdf
yes, if going with a single din radio, you will have to buy a kit to fill in the gap.
the radio owners manual that came with it, a install harness with instructions 2 hours,twist connectors, and understanding.
You need to replace the dimmer switch in your gauge cluster. This was caused by a bad ground happens all the time.
the back seat must be removed then you will find a round access panel this leads directly to the fuel tank which is where the fuel pump and filter should be, by accessing the components this way it keeps from damaging wiring when you drop the tank.
NO! :)) :)) :)) THATS A GOOD ONE ;)
To install an aftermarket CD player in a Toyota Corolla a new wire harness is needed that corresponds with the replacement player. The old radio needs to be removed and the harness will need to connect to the cabin harness. Then the new CD player can be installed.
There is many reason, check fuse,check amplifier and check head unit. Otherwise install an aftermarket radio probably the best thing to do. Pretty simple follow this link http://www.installdr.com/Harnesses/Toyota-Wiring.pdf
how to install TMS003 transistors on Toyota 5fbxc25
replace it with a Toyota starter, not an aftermarket one. aftermarket starters don't last too long because they are only cleaned and sprayed for a nice look. Check the link on the right.
I just replaced the plugs on my 2005 tundra 4.7 v8. they are easy. their is so much room to work with. But do use the genuine Toyota spark plugs. "Do not use aftermarket plugs" i garauntee if you use the aftermarket plugs, you will wreak havoc. the heat range is too high on the aftermarket plugs, and therefore will burn holes in the ignition wires. check eBay for Toyota plugs or your local Toyota dealer.
how to install a blower motor for a 1994 Toyota pickup
how to install a blower motor for a 1994 Toyota pickup
If the aftermarket lights are not a factory option then the lights will need to be drilled into the bumper. Afterwards the lights will also need to be properly spliced into the existed wire harness.
This is the best advise you will get. go to a Toyota dealer (Not any aftermarket parts store) and but a Toyota reman alternator. If you put an aftermarket alternator, you will have problems again. That's good advise from a former Toyota technician. Good luck.
Install left front hedlight 2002 Toyota camre
They are not aftermarket, they just were not done at the Toyota factory. They are factory authorized conversions done in California. I believe the same company may have made GM's convertibles during the late 80's as well.