Typical:
Remove distributor.
Use punch to tap roll pin from gear at base of distributor.
Use an arbor press (not a hammer) to press distributor mainshaft out of gear. Shaft will then easily come free of the distributor. If a hammer is used, now replace the complete distributor.
Unbolt the pickup and replace.
Reinstall shaft and gear being sure that gear hole aligns with shaft hole.
Install a new roll pin.
Install in vehicle.
Set ignition timing.
Check bulbs Check switch
Yes. Front license plates were an available option on 1977 vehicles and the truck is not old enough for a classic or collector exemption.
It is used in extremely cold climates to aid in starting. The block heater keeps the fluids warm for a much faster start.
Answering "http://wiki.answers.com/Q/The_wiring_harness_plug_was_cut_off_your_97_E350_ford_radio_and_you_want_to_install_a_radio_but_you_dont_know_which_is_the_color_for_radio"
I checked again and found a broke cable. Thanks
If it has a distributor it doesnt have a crank position sensor. The magnetic pickup in the distributor is what you would be looking for. The module is either on the side of the distributor or on the firewall against the drivers inner fender.
What is your question?
ford doesnt have a ram pickup ram is dodge
On a 1990 Ford Thunderbird : The 3.8 liter V6 engine distributor rotor turns COUNTERCLOCKWISE
It arcs because something is on when you installed the battery. Can be a light, or relay sticking.
counterclockwise
The 1990 Ford Ranger 3.0 liter V6 engine has a distributor , the 2.3 liter - 4 cylinder and the 4.0 liter V6 have EDIS ( Electronic Distributorless Ignition System )
Install a CD player in ford festiva wb model
1983 was the last year ford made the f100.
will the 5 speed transmition out of a will a 1990 model ford pickup with a 6 cylinder , fit a 1990 modle 302?
if it is a ford ranger,it may work because the masda got its body style form ford for that pickup
The oil pan is bolted to the bottom of the engine