the transmission dipstick tube is bolted (1bolt) to the left rear of the transmission bell housing. Remove bolt and pull up on the dipstick housing to remove it from the transmission fluid pan.
Yes it is. Just because one tube in an amp has gone down, it does not mean another tube has / or is close to. Exception: if the one tube you are replacing has a sibling, in a connected tandem-way (for example push-pull) it is best to replace both tubes with a matching pair. Check with your local dealer on this.
The heater bypass tube is the thin metal tube that comes Off of the water pump to remove it from the water pump all you Need to do is use a torch to heat the pump where the tube Goes into the water pump then wiggle the tube out of the Water pump. The factory put a o-ring on the tube on the Inside of the water pump so that is why the torch is needed to weaken the o-ring so you can wiggle the tube out. If you break the pipe you can clean the edge of the tube And silicone it into the pump or if you don't want to torch The pump just cut the tube out and clean the tube and then silicone it into new pump. If you are buying a new pump the tube does not come with So if you have an autozone or checkers you can go get it From them, it may or may not be in stock. Part name: Heater hose bypass tube Autozone price: $9.95+tax(+ shipping if not in stock) Checkers price: I don't know
Actually three types of chest are distinguished according to the constitutional built:1)Asthenic chest 2)Hypersthenic chest 3)Normosthenic chest
Because "hair" is hair ... and having lots of chest hair makes for a hairy chest.
Chest tube clogging can lead to infection. The chest tube is there to remove fluid from around the lung. If the tube becomes clogged, the fluid builds up around the lung. This fluid can become infected, which is called an empyema. An empyema can require a major operation to remove the thick and infected material from around the lung. Chest tube are more frequently being left in for home care and the patient discharged from home. If the tube stops draining, it either means there is no more fluid to drain, or the tube is clogged. If the tube is clogged and the fluid accumulates, this is a set up for an infection related to a clogged tube.
Chest tube supplies are important after surgery. Chest tube supplies should be kept at a person's bedside for easy access if needed.
a standard chest tube is a hollow tube that inserts into the chest's pleural cavity. a trocar is a metal rod that's inside the chest tube, some doctors prefor the trocar for easier insertion through the intercostal muscles.
movement of fluid in chest tube R/T inspiration & expiration
Chest drainage therapy is done to relieve pressure on the lungs, and remove fluid that could promote infection. Installing a chest drainage tube can be either an emergency or a planned procedure.
If chest tube dislodges, apply pressure over the insertion site with a dressing that is tented on one side to allow for escape of air. If tube gets disconnected, cut the contaminated tip and reinsert a sterile connector and reattach to system or place tip in sterile water. To remove: pt does valsalva maneuver, chest tube is clamped and quickly removed by MD, occlusive dressing applied.
a chest tube is used for the treatment of pnuemothorax or hemopnuemothorax..
stat chest x-ray
Immediately apply sterile gauze over the chest tube insertion site and notify doctor.
guide wire tube thoracostomytrocar tube thoracostomyoperative tube thoracostomy
The doctor will make an incision under the arm, to insert a chest tube. This chest tube will drain off any blood in the lungs, allowing it to re inflate.
32551 - chest tube placement 860.2 - traumatic hemothorax 511.89 - spontaneous hemothroax