0
If someone has applied a lacquer to stop the brass from tarnishing,it's likely that they have used either acrylic or oil based clear from an aerosol can.(some of the acrylics are of good quality) You should be able to remove it with acetone and clean cotton rags.If a 2-part polyurathane is on it, it will need paint stripper, but this is unlikely.
What else can I help you with?
How do you keep the lacquer from peeling on an alto saxophone?
Unfortunately, as far as I know, there isn't really a way to stop this. The best way to help prevent this is to be very careful with your sax, but it's virtually impossible to keep those pestering little scratches off your lacquer.
How do you remove lacquer from a wok?
To remove lacquer from a wok, first ensure the wok is clean and dry. Use a fine-grit sandpaper or a scrubbing pad to gently sand the lacquer off the surface, being careful not to scratch the metal underneath. For stubborn areas, you can also apply a solvent like acetone or paint thinner on a cloth and rub it on the lacquer. Afterward, wash the wok thoroughly with soap and water to remove any residue.
How much is a selmer balanced action tenor saxophone serial number 48314 worth?
Depending on condition and any re-works, i.e. original lacquer >$ than a bad re-lacquer; anywhere from $6,000 to $11,000.
What instrument did bil Clinton play?
Bill Clinton played the tenor saxophone.
What is the smalest saxophone?
The soprillo saxophone.
How do you remove nitrocellulose lacquer?
Lacquer thinner will possibly remove it, chemical stripper will definitely remove it.
How do you remove black tar adhesive?
Lacquer thinner will remove it from most materials.
How do you remove printing on PVC pipes?
Lacquer thinner.
How do you remove lacquer from a stone floor?
To remove lacquer from a stone floor, you can use a lacquer thinner or solvent following the manufacturer's instructions. Apply the solution to the affected area, let it sit for a few minutes, and then scrub the floor with a brush or scrubbing pad. Once the lacquer has softened, wipe it away with a clean cloth and rinse the area with water.
Will lacquer thinner remove dried paint from a paint sprayer?
It depends on the type of paint. Lacquer thinner will remove most oil based and latex paints from a paint sprayer, however, spray gun cleaner will remove it better.
How do you keep the lacquer from peeling on an alto saxophone?
Unfortunately, as far as I know, there isn't really a way to stop this. The best way to help prevent this is to be very careful with your sax, but it's virtually impossible to keep those pestering little scratches off your lacquer.
We want to remove epoxy phenolic lacquer from tinplate sheet's The Tinplate sheet were first coated with lacquer and than heated at 190 degree Celsius.?
To remove epoxy phenolic lacquer from tinplate sheets, you can try using a mixture of solvents like methylene chloride or acetone. These solvents help break down the lacquer for easier removal. It's recommended to wear protective gloves and work in a well-ventilated area when using these chemicals.
Will mineral spirits clean up laquer?
No, mineral spirits will not effectively clean up lacquer. Lacquer is typically thinned and cleaned with specific solvents like lacquer thinner, which is designed to dissolve the resin in lacquer. Using mineral spirits may not remove the lacquer properly and could leave a residue. Always use the recommended solvent for the best results.
How do you remove the lacquer coat used on European marble?
To remove the lacquer coat from European marble, you can use a solvent specifically designed for lacquer removal, such as acetone or a commercial lacquer thinner. Apply the solvent to a soft cloth and gently rub the lacquered area, taking care not to damage the marble underneath. It’s important to test the solvent on a small, inconspicuous area first to ensure it doesn’t harm the finish. After removing the lacquer, clean the marble with a pH-neutral stone cleaner to restore its shine.
How do you remove oil based paint from door hardware?
Use lacquer thinner on a rough rag. If necessary remove hardware from the door.
Oriental Lacquer ?
form_title= Oriental Lacquer form_header= Keep your home beautiful with oriental lacquer. How much lacquer do you need?*= _ [50] Where will you be using the lacquer?*= _ [50] What is your budget for lacquer?*= _ [50]
How do you remove lacquer from marble?
To remove lacquer from marble, start by applying a solvent like acetone or denatured alcohol to a soft cloth. Gently rub the affected area, being careful not to damage the marble's surface. If necessary, use a plastic scraper to lift the lacquer without scratching the marble. Finally, clean the area with a pH-balanced stone cleaner and rinse thoroughly with water.
