Use the wrench that came with the car. Turn counter clockwise.
#26
No, only properly equipped four wheel drives with a Neutral position in the transfer case.
Unscrew it at the base.
No
It pull's off and snaps back on.
under hood fuse and relay diagram for 2002 suzuke aerio
To change the headlight on a 2002 Suzuki Aerio, first, open the hood and locate the headlight assembly. Disconnect the electrical connector by pressing the tab and pulling it off. Remove the retaining clips or screws holding the headlight assembly in place, then gently pull the assembly out. Replace the burnt-out bulb by twisting it counterclockwise, inserting the new bulb, and reassembling everything in reverse order.
I'm sorry, but I can't provide specific radio codes for vehicles, including the 2002 Suzuki Aerio. Radio codes are typically unique to each vehicle and are used as a security measure to prevent theft. I recommend checking the owner’s manual or contacting a Suzuki dealer for assistance in retrieving your radio code.
Take it in Or buy a Scan tool and check it yourself!
The 2002 Suzuki Grand-Vitara has rear wheel drive.
The 2002 Suzuki Grand-Vitara has a 8 ft. 1.6 in. (97.6 in.) wheel base.
To change the spark plugs on a 2002 Suzuki Aerio SX, first ensure the engine is cool and disconnect the negative battery terminal. Remove the engine cover if necessary, then locate the spark plug wires or coils and carefully detach them. Use a spark plug socket and ratchet to remove the old spark plugs, then install the new plugs, ensuring they are properly gapped. Reattach the wires or coils and reconnect the battery terminal to complete the process.
The AC relay for a 2002 Suzuki Aerio is typically located in the engine compartment fuse box. To find it, open the hood and look for the fuse box near the battery. The relay is usually labeled; consult the diagram on the fuse box cover for the exact position. If you have difficulty locating it, refer to the vehicle's owner's manual for more detailed information.
if you jack the passenger side of hte car up then take the protective cover off under the car then you well see it
Timing is done by chain with an automatic chain tensioner. The accessory drive is a belt located on the front of the engine.
To replace the serpentine belt on a 2002 Suzuki Aerio, first, ensure the engine is off and cool. Locate the serpentine belt routing diagram, usually found on a sticker in the engine bay, then relieve tension on the belt by using a wrench on the tensioner pulley. Remove the old belt and install the new one following the routing diagram, ensuring it sits properly on all pulleys. Finally, double-check the belt alignment and tension before starting the engine.
Pound your 2002 Suzuki left front wheel studs out. You will need to pound in the new studs in the same manner that you removed the old studs.