answersLogoWhite

0

First remove the fan troul(if on car), then the body shaft directly behind but still attached I think is a 7/8 crescent wrench will turn counter clockwise.The fan will then come apart from the water pump and you will figure it out from there if not theres something wrong.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is a thermostat in a Chevy beretta v6 1995?

Follow the upper radiator hose to the engine. It is behind there.


Where is the temperature sending unit for a 95 Chevy beretta?

The temperature sending unit for a 1995 Chevy Beretta is on the front of the engine. It is between the front of the engine and the radiator inlet/outlet.


Spark plug gap Chevy beretta 1995?

0.060


I have a 1995 Chevy Beretta with a bad 3.1L and a 1993 Chevy Lumina with a good 3.1L motor is this a possible swap?

the beretta and lumina motors are about the same i have a lumina motor in my 95 beretta


Where is the transmission solenoid on a 1995 Chevy beretta?

inside the transmission bell housing


Where is the fuel filter located on a 1995 Chevy Beretta?

Behind the fuel tank.


Where is the fuel pressure relief valve on a 1995 Chevy Z26 Beretta?

In the gas. Of course.


Why does your 1995 Chevy beretta taillights keep blowing the fuse Help?

then there is a short some where!


Will a 1995 Chevy Beretta 3.1 engine work in a 2001 Chevy Malibu 3.1?

As long as the are both front wheel drive.


How do you replace outside door handles on a 1995 Chevy Beretta?

When you take the old one off you will see how the new one goes on. It's very simple & I've done it! Good Luck!


How do you replace a heater core in a 1995 Chevrolet beretta?

To replace the heater core in a 1995 Chevrolet Beretta, start by disconnecting the battery and draining the coolant from the radiator. Next, remove the dashboard and the center console to access the heater core housing. Disconnect the hoses from the heater core, unbolt it from the housing, and then install the new heater core in reverse order. Finally, reassemble the dashboard and refill the coolant, ensuring there are no leaks.


What is the firing order on a 3.1 for a 1995 Chevy beretta?

1-2-3-4-5-6