Press the FM button
To reset a VW Lupo Beta radio, first, turn the ignition on without starting the engine. Then, press and hold the "TP" and "RDS" buttons simultaneously for a few seconds until the display shows "CODE" or clears. If a security code is required, enter it using the preset buttons. After entering the code, the radio should reset and function normally.
To reset the Audi radio code when it displays "SAFE 2," you'll need to enter the correct security code. First, turn on the ignition but keep the radio off. Then, hold down the "TP" and "RDS" buttons simultaneously until "SAFE" appears. After that, use the radio preset buttons to enter the code, followed by pressing the "TP" button to confirm. If you don't have the code, you may need to consult your owner's manual or contact a dealer for assistance.
TP - Tony Parker album - was created on 2007-03-26.
TO ACQUIRE RADIO SERIAL # AND THEN THE RADIO CODE: turn the car on to accessory mode, but do not start the engine. press and hold the TP button on the radio until you hear it beep...it will take several seconds. Once it beeps, you will be in a menu, and use the right knob (the one you use to tune channels) to scroll through the options until you see the serial number. It will most likely say SERI followed by an 8 digit # like "SERI 00154848". Call your porcsche dealer and speak with the service department. Give them this serial number and they SHOULD be able to give you the code. Sometimes they want to charge you, but i work for a dealership myself, so our porsche dealer knows who i am. It's worth a try though!!
Turnpike Ordinance
To reset the Audi radio code when it displays "SAFE 2," you'll need to enter the correct security code. First, turn on the ignition but keep the radio off. Then, hold down the "TP" and "RDS" buttons simultaneously until "SAFE" appears. After that, use the radio preset buttons to enter the code, followed by pressing the "TP" button to confirm. If you don't have the code, you may need to consult your owner's manual or contact a dealer for assistance.
I have the same problem, I pressed the button ON with the key 6 or TP maintained. The code 1000 is displayed but I only can change the first digit.
I think you hold down the tp button, not 100% though to be honest.
To unlock your 1999 VW Cabrio radio after obtaining the code, first, turn on the ignition without starting the engine. Then, turn on the radio, which will display "SAFE." Press the "TP" button and hold it while simultaneously pressing the "MODE" button to enter the code entry mode. Use the preset buttons (1-4) to input the code, and once entered, the radio should unlock and begin functioning normally.
tp many things to think about it
The dome light should stay on for about 15 seconds and then go out as a courtesy light. If it stays on all the time you probably need to check the dash and turn it off. Usually the dash light dimmer rotates tp a point that will turn it off.
Apparently it has something to do with if your TP button is on for traffic reports and it can't lock a signal to it. Annoying isn't it!!??
Ensuring electrical switches are off
up tp 5-10 days
TP-Link was created in 1996.
The population of TP-Link is 14,000.
Heitor TP was created in 1993.