If your amp has a "line out" jack (most likely on the back of amp), you can run a patch cord from the line out jack to an input jack on your mixing board. An earphone jack will work also, but not quite as well, as that is not what it was specifically designed for.
A HDMI cable is used to connect a behringer mx400 mixer to a behringer head amp. This can be bought at just about an big store.
mixer is when you ix the music only but he dj amp i for all the gear like speakers mixers turntables and stuff.............
The RCA's from the amp will be arn to the CD player, then you need to connect the speaker's wire to the output + and - of the amp, this will cause the amp to have musical power from your radio, and the speakers to have the power from the amp..-Shocker
You should be able to connect to the amp.
To run a monitor speaker or to connect several amps in series to pre-amp your amp.
A HDMI cable is used to connect a behringer mx400 mixer to a behringer head amp. This can be bought at just about an big store.
I have connected 4 to that mixer and it was too much. You will most likely take out the amp. if you connect 6. Two is about all it can handle.
mixer is when you ix the music only but he dj amp i for all the gear like speakers mixers turntables and stuff.............
you cant hook a woofer to player! you could connect woofer to mixer or amp A cdj is only a CD player in the same way a car player needs a source of power to push the sound to your speakers so does the CD as said you need a amp if your sub woofer is preamped then technically you should be able to connect it directly to it but you will need to be careful of the sound output and realise that you will not be able to control the levels as well compared to if you were using a mixer or amp.
No. To use an MD-12 in as a sound re-enforcement mixer, you will need to have a separate power amp.
mixer main out TO behringer feedback destroyer input TO speakers
Basic equipment 1.Cd players / turntables 2.Mixer 3.Speakers (Active - not needing a amp or Passive - Needing a powered amp) 4.Amp (If needed) 5.Headphones 6.Microphone 7.Wiring a) phono leads - red and white wires from CD player to mixer b)Xlr - from the mixer to the amp or speakers c)Speakon leads - from the amp to the speakers and not forgetting..... 8.Music!
I am buying the new dj how dou connect with speekers
Yes you can connect it out of AUX send. infact that is the best place to connect it from
The RCA's from the amp will be arn to the CD player, then you need to connect the speaker's wire to the output + and - of the amp, this will cause the amp to have musical power from your radio, and the speakers to have the power from the amp..-Shocker
To find a cheap price for a mixer amplifier one can visit an auction with already used mixer amplifiers. This can be done on eBay. Other alternatives are bhphotovideos and fullcompass.
You should be able to connect to the amp.