How to take out the radio of a 95 Mazda millenia?

Answer 1

On my 1993 MPV it is like this.

Remove the ash tray. Remove the 2 screws holding the plastic frame, now visible on the bottom of the ash tray holder. Unsnap the frame from the bottom. Unscrew the cigarette lighter bulb holder and unplug the cigarette lighter connector to get them out of the way. There are 5 screws. 1 in each corner and one in the bottom center. Unscrew them and pull the radio out just far enough to see the plastic molex connectors. There are 2 plug connectors and the antenna wire connector. Unplug them and plug into new radio. Put it back together.

Answer 2

Using the link below remove the console (labeled as "A" in the diagram) by removing the 4 Philips screws on the side. The console containing the radio will then slide out allowing you access to disconnect the wires and remove the radio.

Answer 3

It depends if you have the stock radio there are little plastic vertical end covers that hide in total four holes both left and right. There are DIN removal tools you can get at Walmart or RadioShack that you insert in the holes and allow you to remove the radio from the dash. After you pull the unit partially out, you can access the rear plugs you have to disconnect, including the antennae.