answersLogoWhite

0

What else can I help you with?

Continue Learning about Music & Radio

Why won't my music player stream music through an aux cable - the music plays through the speakers but not the aux output - I think it's a setting in windows 7?

Make sure your computer settings have allowed the aux output of your computer to actually act as an output - some computers have a 3.5mm input (the aux input) that acts as both an input and an output (the Macbook Pro 13inch is an example) and in control panel you need to set it to output, no input. Also, if you have several 3.5mm input/outputs then you need to make sure you're plugging the speakers into the right plug - it will be a green one that usually has a picture of some headphones next to it. It may be an issue with your speakers, test with an iPod or something similar to see if they even work. Sometimes it is even just an issue with your volume on the computer when you put the speakers in, check for that, too. Hope this helps.


What is the Difference between linear IC and digital IC?

Both linear ICs and nonlinear ICs has an output voltage which is dependent on the input voltage. However, the difference is that linear ICs produce an output voltage which increases or decreases at a "fixed rate" relative to the input voltage. Nonlinear ICs do not do this. A voltage regulator may be considered nonlinear because as you increase the input voltage the output will climb at the same rate (just like linear ICs), however, once the input voltage reaches a particular level point, the output no longer increases as you increase the input. This is at the point where regulation begins. The nonlinear IC no longer changes its output at a fixed rate relative to the input.


How an amplifier can be converted to a oscillator?

By introducing positive feedback from output to input


How do you plug a microKorg into a boss loop pedal?

Microkorg output to boss looper input.


Why an open ttl gate behaves as a logic high input?

because TTL have a bias input setup to eliminate noise therefore the output will follow the logic one input if left open