See web site http://www.stsi.biz/eeu-fc0j272l.html
The short lead is the negative side.
It's Billie Joe Armstrong, which is NOT short for William Joseph.
The name of the lead singer from Crown The Empire is Andy Leo. His real name is Andrew, but some people say Andy for short :)
Vampire Weekend got their name from the title of a short film made by the band's lead singer Ezra Koenig.
Yes she did because she was getting older, she didn't like being at the back singing for few seconds and she wanted to be the lead singer like nicole... But she only sang a short solo in the song beep.... Yes she did because she was getting older, she didn't like being at the back singing for few seconds and she wanted to be the lead singer like nicole... But she only sang a short solo in the song beep....
Nope its 100% real hair. Recently Andy Beirsack (the lead singer) got a haircut so his hair is now short :)
The arrow always points to the negative lead.
Normally all electrolytic capacitors negative lead is marked on the side and if the plastic cover came off and it is new the long lead is the positive.
If the capacitor is and electrolytic then YES, you must keep the +ve to the side with no marking or a + and -ve to the side with a stripe or a - on it. If the capacitor has one leg shorter than the other the shorter leg is also the -ve side. Connecting an electrolytic the wrong way round can cause it to boil or even explode. If it is not electrolytic then it can go either way round, these are usually smaller.
Capacitive reactance is -1 / (2 pi f C), so the reactance of a 330 µf capacitor at 60 hz is -8 ohms. (The negative sign simply means that the current will lead the voltage.) However, an electrolytic capacitor is not designed for operation on AC, as it can only have voltage applied to it in one direction only. The equation still holds, however.
A common choice is an electrolytic capacitor with a high enough voltage and capacitance rating to stabilize the voltage. To wire it, connect the positive lead of the capacitor to the positive terminal of the car battery, and the negative lead to a good ground point on the vehicle's chassis. Be sure to add an appropriate fuse in line with the positive lead for safety.
The positive leg is usually indicated with a red dot. Sometimes there is an white arrow that looks like a minus sign - that is the negative terminal. If it is a can type, the can is the minus terminal and the tab(s) is(are) the plus terminal(s).
The distance between the leads (lead spacing) on a radial capacitor
A polarized ("polar") capacitor is a type of capacitor that have implicit polarity-it can only be connected one way in a circuit. The positive lead is shown on the schematic (and often on the capacitor) with a little "+" symbol. The negative lead is generally not shown on the schematic, but may be marked on the capacitor with a bar or "-" symbol. Polarized capacitors are generally electrolytics.
The Lead Capacitor
You charge a capacitor by placing DC voltage across its terminal leads. Make sure when using a polarized capacitor to place positive voltage across the positive lead (the longer lead) and negative voltage across the negative lead. Also make sure that the voltage you charge the capacitor to doesn't exceeds its voltage rating.
1. The capacitor has Lead resistance in series with the capacitor2. Since most capacitor use Dielectric and they have a leakage resistance and it is parallel to the Ideal Capacitor.
Capacitor lead length is a consideration in a circuit when the frequency involved is sufficient the make the parasitic capacitance and inductance of the leads important.