answersLogoWhite

0

there is a screw behind ash tray and two above radio and three at top .To access top screws carefuly pry cover off where the security light is.This will release the bezel.In order to replace you will need to do a relocation of the factoryradio due to ac controls.In mine i made a custom panel to house only ac cont. below ash trey.looks great and clean but alot of work.Should be done by profesional only.veiw or contact me @ ncsoundsandsecurity.com.Hope this helps

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What model is this Isuzu SUV with VIN 4s2de58y744602620?

2004 ISUZU AXIOM/AXIOM XS


How do you install a water pump on a 2004 axiom?

how do you install a water pump on a2004 Isuzu axiom


Is there anyone who has an Isuzu Axiom and has nothing but trouble with it?

yes i have a 2004 axiom and i have had a lot of problems with it. expensive problems.


Where is the location of the blower motor on a 2004 Isuzu Axiom?

The blower motor on a 2004 Isuzu Axiom is located under the dashboard on the passenger side of the vehicle. To access it, you may need to remove the lower dash panel. The blower motor is typically mounted near the firewall and can be identified by its round shape and electrical connector.


What type of transmission fuild is used in the 2004 Isuzu axiom?

Dextron III


How do you replace an alternator 2004 Isuzu Axiom?

To replace the alternator on a 2004 Isuzu Axiom, first disconnect the negative battery terminal to ensure safety. Remove the serpentine belt by loosening the tensioner and then unbolt the alternator from its mounting bracket. Disconnect the electrical connectors and remove the old alternator. Install the new alternator by reversing the steps, ensuring all connections are secure and the belt is properly tensioned before reconnecting the battery.


How do I replace brake light on 2004 Isuzu Axiom?

To replace the brake light on a 2004 Isuzu Axiom, first, open the rear hatch and locate the tail light assembly. Remove the screws or clips holding the tail light in place and carefully pull it out. Disconnect the wiring harness, then twist the bulb socket counterclockwise to remove the old bulb. Replace it with a new bulb, reassemble the tail light, and ensure it’s securely fastened before testing the brake lights.


How do you remove the interior door panel on a 2004 Isuzu ascender?

How do you remove the interior rear door panel on a 2004 isuzu ascender?


How do you remove door panels on 2004 Isuzu axiom?

To remove the door panels on a 2004 Isuzu Axiom, first, ensure that the window is fully closed. Start by removing any visible screws, typically located near the door handle and armrest. Use a flathead screwdriver to gently pry off the panel, starting at the bottom and working your way up to detach any clips. Finally, carefully lift the panel away from the door, disconnecting any electrical connectors for window controls or speakers as needed.


How much does 2004 Isuzu weigh?

The weight of a 2004 Isuzu can vary depending on the specific model. For example, the 2004 Isuzu Rodeo has a curb weight of approximately 3,500 to 4,000 pounds, while the Isuzu Axiom weighs around 4,000 pounds. It's best to consult the owner's manual or manufacturer's specifications for the exact weight of a particular model.


Where is the crank sensor located on a 2004 Isuzu axiom?

Isuzu part number 8-97258-523-0(MSRP $193.86) crank sensor is on the right side(passenger) of the engine block, just behind the mount.


Does the 2004 Isuzu Axiom share the same transmission and transmission failures as the earlier 2002 and 2003 model?

No, the 2004 model features an Asin transmission as opposed to the GM transmission that was used in 2002-2003.