0
above the stereo, there is the cover look under it and you should see a little button. push the button in and remove that cap.
you should be able to see your fuse box. then you will see 4 screws above the climate control. the 2 outer screws are for the vents which is connected to the stereo.
take those 2 screw out and use a flathead to pry along the sides of the vents and then pull it out.
your stereo should come out along w. the vents. then pop the deck from the frame and you can then change it.
What else can I help you with?
Does the TM4000 radio on 1992 Previa you have a 'Pre-Amp' if so where is it I have tried another working radio but it will not work on the Previa?
It may be under the drivers seat as on the lucida. If changing radio to standard you need to bypass the amp unit and wire radio to speakers direct. This means connecting all speaker wires to the ones that go from the old radio to amp unit. You will need to make a note of all connections as you do them all one by one. Tricky if your not experienced with wiring.
How do you remove the radio from a 1992 Lexus SC400?
You have to remove the center dash panel to get access to the bolts, screws.
When did Radio RSA end?
Radio RSA ended in 1992.
Your 1992 Toyota 2 wd 4-cylinder truck started fine yesterdayI tried replacing the fuel filter and it won't even turnAll the lights and radio workIm broke and about to lose your jobPlease help?
Remove the cables going to the battery, clean the posts and the cable ends, replace. This might help.
When did Yugoslav Radio Television end?
Yugoslav Radio Television ended in 1992.
Remove Tape deck from 1992 Toyota Previa?
remove the radio.and once outside remove the tape deck wich is screw to te radio.
How do you replace speed sensor on 1992 Toyota Previa and where is the sensor located?
How do i replace speed sensor on 1992 toyota previa and where is the sensor located
Why cant i get hot air from vents on Toyota Previa 96?
where is the heater core in a 1992 Toyota previa
Where is the idling switch located on a 1992 Toyota Previa mini van?
The location for the idle switch of a 1992 Toyota Previa mini van can be found in the Toyota Previa Auto Repair Manual 1991 thru 1995. This can be purchased from the Toyota dealership.
Why isn't 1992 Toyota Previa not downshifting?
If it is not not downshifting, then it is downshifting.
Does the Toyota Previa 2.438GL automatic 1992 petrol have a cambelt or chain?
almost all engine's in toyota Previa 2,4 l have timing chains .
How do you remove the corner tail light cover on a 1992 Toyota Previa in order to change the rear turn signal?
Remove the light assy then turn the bulbs countereclockwise to remove the bulbs.
Toyota Previa 1992 won't start no spark?
check the Distributor.
What kind of brakes are on the back drums or discsi have a 1992 Toyota Previa le?
my 92 is dics
What is the valve cover gasket torque sequence on a 1992 Toyota Previa?
35 foot pounds
How do you fix a bent rear wheel hub of a 1992 Toyota Previa?
if its the hub it self then its a axle change.
Where is the inertia switch in a 1992 Toyota Previa?
In a 1992 Toyota Previa, the inertia switch is typically located in the engine compartment, mounted on the driver's side near the fender. It is designed to cut off fuel supply in the event of a collision. To access it, you may need to remove some covers or panels in the area. Always refer to the vehicle's manual for specific location details and safety precautions when working on the vehicle.
