Want this question answered?
No, you can't get 8 ohms with 4 16-ohm speakers. Here are the possible wirings: +o-+o-+o-+o- all in series: 64 ohms |+o-+o-| |+o-+o-| series parallel: 16 ohms |+o-| |+o-| |+o-| |+o-| all in parallel: 4 ohms .... Well in the conventional way it is not possible. But think of the speakers as load attached to the secondary of some transformer while the primary coil is attached to the amplifier block before (a tuned amplifier type). If we adjust the turns ratio as n = primary:secondary = Sqrt(2):1, then the eefective load on the amplifier would be Reff = n^2*Rp. Now as pointed in the parallel connection, Rp = 4. So, Reff = 8 Ohm.
After FM demodulation to the original AF signal it is necessary to amplify the weak AF signal to have enough power to drive speakers. That is the purpose.
If you connect three 4 ohm speakers in parallel, the amplifier would see a load of about 1.3 ohms. This definitely could damage the amp if you drive it too loud.
The front speakers located in the front doors I believe are 6 inch speakers. The rear speakers are 6 inch X 9 inch speakers.
No the MicroKorg does not come with speakers. You need to purchase a separate amplified speakers.
in parallel No. Two 8 ohm 'speakers in parallel present a 4 ohm load.
Parallel
They will work OK. When a speaker is rated at 250 W that is only a maximum and speakers will work will less audio power. Putting two speakers in parallel will double the total audio power output for a given volume setting.
They will work OK. When a speaker is rated at 250 W that is only a maximum and speakers will work will less audio power. Putting two speakers in parallel will double the total audio power output for a given volume setting.
A trapezoid, or a trapezium for non-American speakers.
No. Two 16 ohm speakers connected together are either 32 ohms, if wired in series, or 8 ohms, if wired in parallel. You can, however, connect four 16 ohm speakers in series-parallel to get 16 ohms, with four times the power handling capacity of just one.
4ohms in series,2ohms in parallel.
The audio signal to the speakers are not cut off since the connection to the front panel and speakers are in parallel.
Speakers can be wired in parallel or in series. Take the speaker wire from the output, and wire the speakers like so: (ignore the squiggles, they represent spaces) ----|------| S S ----|------| For a parallel wiring. This will reduce the impedance of each speaker, though, so two ohm speakers should be used insead of four ohm speakers. Wire them like this: ----| S | S ----| for series wiring. This will increase impedance though, so eight ohm speakers should be bought instead of four. You will be fine using four ohm speakers in either case, but will lose clarity.
Just use it like an 8 ohm speaker or else connect two 16 ohm speakers in parallel to form an 8 ohm load. Parallel is positive to positive and negative to negative.
Upgrading your computer speakers will also a greater range of sound to be broadcast, so in most cases, new speakers would give you an increase in sound quality.
In "The Giver," the speakers are in every dwelling to broadcast announcements and instructions from authorities. This is a way to control and monitor the residents, ensuring compliance with rules and regulations in the community. The speakers also allow for communication during emergencies or important events.