what exactly means
No. All states honor each other's motor vehicle codes, regulations and court decisions.
To reset the EDC (Electronic Diesel Control) for a Mercedes-Benz Vito W638, you typically need to disconnect the battery for about 10-15 minutes to clear any stored error codes. After reconnecting the battery, start the vehicle and allow it to idle for a few minutes to let the ECU recalibrate. If issues persist, using a diagnostic scanner to read and clear any fault codes may be necessary. Always consult the vehicle manual or a professional for specific procedures related to your model.
I'm wondering if you are looking for a list of the Diagnostic Trouble Codes and what they mean or if you are wanting to know how to get any codes that may be stored on board due to a fault that's occurred. On model years 96 and later the only way to obtain the codes is by using a scanner that plugs into an outlet typically located under the dash on the drivers side near the side wall. The scanner will display any active codes. It would probably be less expensive to just take the vehicle in to a repair shop that has a scanner than to buy one. If you want a list of all codes that can be shown you can obtain these codes and an explanation of each by purchasing one of the popular repair manuals from publishers such as Hayes or Chilton. Usually these manuals are available at your local library in their reference section and contain a wealth of other information. Hope this helps and Good luck to you !!
It would be vehicle 1 because it made vehicle 2 get hit by vehicle three who had nothing to do with it
The security codes for each radio are unique. There will be a card with the number in the original manual supplied with the vehicle when purchased new. There you will also find the procedure for unlocking the radio. If you do not have the original card containing the code you may go to your nearest Mercedes Benz dealer with I.d and proof of ownership of the vehicle and they will be able to get the code and tell you the procedure.
A VC4000A charge means that you have driven or parked a vehicle on a California highway while it was not properly registered. The only way to fight this charge is to prove the fees were paid before you were pulled over.
Have vehicle scanned to determine the problem and have codes cleared
no like if it's a famous or pupular holiday then they post codes to get a vehicle
Pulling a fuse will not clear codes on this vehicle. A scan tool is required to clear codes.
The scanner can erase codes but if there is a problem the codes will immediately come back. So the answer is no.
Vehicles use generic codes, enhanced codes and manufacture-specific codes. So you must use a shop manual to get the codes used in your particular vehicle.
Not sure of that code in particular, but U codes are generally communication errors between the various modules of the vehicle
Nice answer. For any vehicle, try looking up your codes here: http://www.obd-codes.com/trouble_codes/
Your vehicle used the OBDII computerized system, Look here for the codes and their meanings.What_are_the_different_OBDII_trouble_codes_and_their_meanings
codes on a obd2 vehicle will clear if ether the vehicle has go threw 40 to 80 warm up cycles or a scan tools is used to clear a code. codes should only be cleared after the repair on the component or system fault.
Unlock codes on Chevrolet pickup trucks are part of anti-theft systems and vary from vehicle to vehicle. Radio codes can be found the owner's manual of a vehicle or an owner can choose to pay to reset the code by taking the truck to a dealership.
Have vehicle scanned to determine the problem and have codes cleared