RPM mean 'revs per minute', the speedometre only shows numbers 1 to 9but then you times it by 1000. It is bacicaly how many revs your engine produces in one minute at the current rate of use. :-)
Add 2 quarts of Honda 4stroke motor oil then check the level @ dipstick and adjust accordingly. Good luck & don't forget to change the oil filter.
Detroit is known as the Motor City. It is called the Motor City because it is the historic heart of the American automotive industry. Another nickname for Detroit is Motown.
Use a test light connected to the fan motor - if it lights fan motor is bad if it does not light could be fuse, relay, switch, or resistor
According to what I know, rapping motor is the motor that is connected to rapping system. Rapping system may contain a shaft with a lot of hammers hanging on it. The function of this rapping system is to give impact force that will result in vibration of the parts that are hit.
Its located on the passengers side of the vehicle under the dash right next to the recirculating vent and the vacuum motor...........
It is measured in cubic inches, cubic centermeters, or liters. It is the area of the bore of the piston and the stroke of the piston. In other words how big that hole the pistons resides in when the piston is all the way down. You multiply that by the number of pistons in the engine.
It Has 4 pistons A cylinder is the central working part of a reciprocating engine, the space in which a piston travels.
It may not mean anything at all. Motor oil is used to lubricate and cool the pistons. If there's a lot on the side of the pistons, then it's possible that you need to replace the piston rings.
They are the hollowed out shapes/areas in the motor block, which the pistons move up and down through. The petrol is let into the cylinder, when piston pushes up, the petrol explodes and pushes the piston down. The bigger the cylinder the bigger to push, the more powerful the motor.
You take the motor apart, pull out the pistons and throw them into a skip. After that tryu to start it with a torque wrench
You can run a piston with any sort of power, steam, hydro, electric motor. Electric motors are often used to move a piston in pumps, but the rotary type pump is much more efficient. Today steam is normally used to move a turbine, not a piston. Most pistons are used in internal combustion machines and are used to capture to power of the explosion.
Detroit is the birthplace of the automobile and the motor industry. A piston is one of the most energetic moving parts of an automobile engine. The pistons drive the vehicle. The Detroit Pistons chose that name to suggest that the players are energetic and fast, and that they drive the team.
It had a turbine engine, not a motor with pistons.
Your rods for pistons 1 and 3 and probably backwards
no no no no no, and once again to solidify my point, no! as the engine is used your pistons, and cylinder walls wear in a certain pattern, and they have a different level of wear from car to car, what you have to do generally is send the motor to a machinist to bore the cylinders out slightly, then get new oversized pistons
it runs faster than a 4stroke but use mixed gas in the to stroke
basically cylinders are fitted with the pistons used in the engine of a motor vehicle. these pistons are been used for the combustion of the fuel and its purpose is to transfer force from expanding gas in the cylinder to the crankshaft via a piston rod and/or connecting rod. In a pump, the function is reversed and force is transferred from the crankshaft to the piston for the purpose of compressing or ejecting the fluid in the cylinder. In some engines, the piston also acts as a valve by covering and uncovering ports in the cylinder wall.