from front to back the piston numbers are 123456 the firing order is 153624 the #1 on the distributer is(if you are standing on the passenger side looking at the distributer it is the bottom right.
A 1998 Jeep Cherokee has disc brakes in the front.
What's the question?
1985-1996 Jeep Cherokee XJ should interchange 1997-2001 Jeep Cherokee XJ should interchange
A 1998 Jeep does not have a cabin filter.
Assuming you are asking about a 4.0L engine... Remove the distributor cap. Remove the rotor. Unplug the camshaft positioning sensor from the harness. Lift carefully where the cable feeds through the distributor to the CMP and remove. Put replacement CMP in the same place and connect it to the harness. Replace the rotor and distributor cap. Courtesy of xjtalk.com
4liter is in distributor.
Inside the distributor.Inside the distributor.
"how do you change a throttle position sensor on a 1998 jeep grand Cherokee?" could someone without any experience do it?
The cam position sensor is inside the distributor. The crankshaft position sensor mounts through the top driver side of the bell housing.
It is inside the distributor.
A 2003 Jeep does not have a distributor.
At tdc compression it should be pointing at #1 on the distributor cap.
You cannot !
A 1998 Jeep Cherokee has disc brakes in the front.
A 1998 Jeep Cherokee uses R134a.
The camshaft position sensor is inside the distributor. The crankshaft position sensor is in the top of the bell housing on the driver side.
The distributor is set to zero with a scan tool. It is not done with a timing light.