The cam position sensor is inside the distributor. The crankshaft position sensor mounts through the top driver side of the bell housing.
"how do you change a throttle position sensor on a 1998 jeep grand Cherokee?" could someone without any experience do it?
4liter is in distributor.
The crankshaft position sensor is on the top driver side of the transmission bell housing.
A 1998 Jeep Cherokee does not have a mass airflow sensor. It uses a manifold pressure sensor, MAP, which is on the rear of the intake manifold.
The sensor can be checked by the use of an ohm meter on the sensor terminals. Unfortunately I do not have the specific data for this vehicle.
where is the throttle position sensor on a 1998 Toyota 4runner???? can any one help???
The throttle position sensor is located on the throttle plate.
To change a throttle position sensor on a 1998 Bravada, disconnect the negative battery cable. Separate the wiring harness connector on the throttle position sensor and take off the sensor. Replace with new.?æ?æ
The speed sensor is located on the drivers side of the transfercase, you will see a sensor with a connector, that is your sensor.
The vehicle speed signal (speedometer) comes from the abs sensor on the rear axle.
Where is can position sensor located on 1998chevy 3.1engine
IN THE WATER JACKET.