answersLogoWhite

0

if this is like my 89 don't worry about the diagram if you don't have the amp. This is wrecking yard material. Find that car in a wrecking yard and then get the amp and the wiring harness and clip the harness so you have enough wire to splice the same colors together. Radio Shack has match melt solder strips and heat shrink tubing to make the splicing easy. Or at this point probably cheaper to just rewire the whole stereo system with an aftermarket system

And if your thinking about using a mark 7 factory amp for somthing else you wasting your time most normal head units produce as much power as that, your question is a little unclear i guess is what im trying to say.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you locate the 1997 Mark VIII Stereo speaker wiring diagram?

if your not going to use the old factory stereo, take it apart and you will find that the circit board is labled where it plugs in. Or go to your nearest stereo shop and get a wiring harness for $20.


How do you put a after market stereo in a Lincoln mark 8?

To do it correctly the speakers will have to be rewired and a new wiring harness installed.


How do you remove the door on a 1998 ford explorer?

disconnect wiring harness, mark hinges, remove bolts securing hinges to body.


Why doesn't the audio work with an aftermarket stereo in a 1994 Lincoln mark 8?

Needs a wiring harness, can't just put in an aftermarket stereo without re wiring the speakers etc.


Where can you get a free wiring diagram for a 1994 Lincoln mark 8 factory JBL stereo?

Check out Crutchfield at the link below.


1990 Lincoln mark vii door speaker wires?

The speaker wires have 2 pin connectors that connect to the coaxial speakers in the doors.. If looking to upgrade speakers make sure you do research on the physical size of the new speaker as there might be issues. Also you can pick up a wire harness to connect the factory wire harness that is mounted to the door to a new set of speakers.


Installation for a power antenna for 79 Lincoln mark v?

To install a power antenna on a 1979 Lincoln Mark V, first disconnect the negative battery terminal for safety. Remove the old antenna by unscrewing it from the fender and disconnecting the wiring harness. Mount the new power antenna in the same location, ensuring it’s securely fastened and connected to the wiring harness. Finally, reconnect the battery and test the antenna to ensure it operates correctly.


What could be causing the fuse for the dash lights to keep blowing on a 1988 Cherokee Laredo?

Short in the wiring. If you have a trailer wiring harness check it for frayed wires. The tailight circuit and the dash lights share a circuit on many vehicles. I hope this helps you. Mark


I need The wiring diagram for the tripminder in a 1990 Lincoln mark 7 lsc se?

look in eBay for a EVTM manual for your vehicle. not sold in stores-


How do you Replace window regulator and motor 1994 mark VIII?

its easy just take off the door panel, disconnect the wiring harness and take the screws out of the mount for the window motor and it comes rite out


Where is the starter on a 1990 Lincoln mark vii?

Where is the starter on a 1990 lincoln mark 7


How do you change the lighter socket in a 1998 mark viii?

To change the lighter socket in a 1998 Lincoln Mark VIII, first, disconnect the negative battery cable to ensure safety. Next, carefully pry off the trim panel surrounding the lighter socket using a flathead screwdriver or trim tool. Remove the old socket by disconnecting its wiring harness and unscrewing it, then install the new socket by reversing the process—attach the wiring harness and secure it in place before reassembling the trim. Finally, reconnect the battery and test the new socket to ensure it works properly.