Early on David Gilmour used a fender twin reverb and some kind of old tape echo, now i believe he uses Hi Watt amps that were made back in the 70s , he uses lots of effects but his primary sound comes from a Big Muff , a Chandler Tube driver and a boss delay, he also uses chorous at times which is also boss, im pretty sure he also uses a compresser some .. His Statocaster had had the whammy chopped back and the pickups replaced ..
The send out of the amp to the in of the effects, the out of the effects to the send in of the amp.
Wet means the amp sound has effects, while dry is no effects.
Line 6 Jam amp
He uses a lot of different ones. There is no specific amp he always uses. But some of what he has used includes: Mesa Boogie Triple Rectifier amp head Marshall JCM 900 amp head Mesa Boogie 2:90 power amp Triaxis preamp Marshall EL34 power amp JMP-1 preamp
Uhm. You might already know this but for Metallica distortion is #1!!! Make sure your amp has good distorition or it's not goiung to sound very legit.
To achieve the signature Pink Floyd sound, it is recommended to set your amp with a clean tone, moderate gain, high treble, and a touch of reverb. Experiment with these settings to find the sound that best captures the iconic Pink Floyd sound.
The send out of the amp to the in of the effects, the out of the effects to the send in of the amp.
Wet means the amp sound has effects, while dry is no effects.
To incorporate an effects loop into your amp if it does not already have one, you can consult a professional technician or purchase an external effects loop pedal that can be connected between your guitar and the amp. This will allow you to add effects pedals into the signal chain without altering the amp itself.
space notes as in like all pink floyd or "galactic" type stuff that aliens would? You'll need a chorus or flange pedal for this. Your best bet is to get a guitar processor or modeling amp with it in it.
Line 6 Jam amp
After you have an instrument, a cable, and an amp, you should learn basic plucking technique. Learn all the notes, learn scales, and then try to learn a few basic songs (Money by Pink Floyd is a good one).
It depends on the amp and what the amp is being used for and what kind of automotive it is.
15 effects
To connect a multi-effects pedal to an amp, you will need two instrument cables. First, plug one cable from your guitar into the input of the multi-effects pedal. Then, connect the output of the pedal to the input of the amp using the second cable. Make sure to set the pedal and amp to the desired settings and levels for your sound.
Gain effects lie overdrive, compressor etc go between the guitar and amp, time based effect eg flange, chorus go in the effects loop.
Pretty much any kind you can afford and install.