ice cream
To fit a radio in a Peugeot Expert, start by carefully removing the dashboard panel using a trim removal tool to avoid damage. Disconnect the existing radio by unplugging the wiring harness and antenna. Install the new radio by connecting it to the wiring harness and securing it in place, then reattach the dashboard panel. Finally, test the radio to ensure it powers on and functions correctly before fully reassembling.
You can get one on eBay for $3.99
Live streaming
One the face of the radio on both the left and right there should be two small flaps that fli[ open. After open use a hex tool to loosen. You may need a special tool if the hex fails. Next pull the radio out and disconnect the wire. Before doing any work on the radio though disconnect the battery.
radar
There are two clips that hold the radio in place. You just need to use a hook tool and remove the clips and the radio will slide out.Ê
2001-2002 Honda civic radio removalStart by removing the cigarette lighter panel. Insert a hook tool behine the panel and pull outward to release the retainer clips. Inside the panel opening at the top are two 8mm.hex head bolts that hold the bottom of the radio inplace. Next remove the trim bezel around the radio/climate control module. Insert the hook tool under the bezel and pull firmly. Work all the way around the bezel to release all the clips. Pull the unit out and remove all the wiring conectors. Now you have four 8mm. hex head bolts to remove and your radio is out.
A tool that has a hook on the end.
grass hook is useful to the gardener and useful tool
You can check in the Eckler's catalogue. I think there is a tool you can buy, kind of like a hook.
You have to have a tool from Ford. But.....if you take two (2) small pieces of wire and notch the ends (kind of like a barb on a fish hook only duller not sharp) you can slide them in and unlock the radio. once you feel the notches lock, just pull it out.
To make a hook in Little Alchemy, combine "metal" and "tool." First, create metal by combining "fire" and "stone" to make "metal." Then, combine the metal with "tool" to craft a hook.
A power tile saw is the best tool for removing tile effectively and efficiently.
remove the bottom half by using a hook tool. it only uses snaps to hold it in. once removed there will be 4 10mill bolts holding the radio in place. 2 of which are in the lower upper corners; once removed radio will slide out.
A fishing pole, bait, and a hook.
Yes there is,Grappling hook
its a tool used to pull animals from the water it has a sharp hook on the end of its handle. The hook was used to pull harpooned animals out of the water.