Usually a bad turn signal flasher
Blown bulbs not pulling enough current to cause flashers to operate. Check your bulbs...
Go to Autozone.com and you can find out what flasher, and where it is located. :)
When you use your turn signal flashers, the clicking sound typically associated with turn signals may not be audible due to a few reasons. Some vehicles are designed with electronic flashers that operate silently, eliminating the clicking noise. Additionally, if the vehicle's turn signal relay is malfunctioning or if there's an issue with the speaker that produces the sound, you may also not hear the clicking. Lastly, if the vehicle is very quiet or if you're driving at high speeds, external noise may drown out the clicking sound.
pull the turn signal lever toward you.
The turn signal flasher is located in the fuse compartment. The fuse compartment is located under the steering column on the interior of the car. The flasher fuse is round and silver. Hope this helps.
try turning on the emergence flashers then they will work i have that problem after i do that it seems to work
You may have a relay problem your flashers and turn signal are on different relays or there could be a problem with the wiring in the steering column that goes to the turn signal
where are the flashers located
No gurarantees, but most car signal flashers are plugged in at, or near the fuse box - try there.
Underneath the driver's side dashboard tucked way up on the firewall. You will see a round cylindrical item. There are separate ones for the hazard flashers and turn signals, so make sure you pick the right one. .
Check two things: 1) the fuse for your flashers/blinkers and 2) that the bulbs are good still.
The Turning Signal Flasher is under the hood in the drivers side fuse box. When you remove the cover from the fuse box you will see the fuses but no relays / flashers. You must then remove a second cover. The snaps are along the side of the box. This will expose the relays and flashers for the 2004 Chrysler Crossfire.
The signal and 4-way flashers are behind the lower dash panel, aprox under the radio. The lower dash panel must be removed to gain access to the flashers.
The Signal electrical Control is located in the column of driving wheel, the flashers located under the dask
replace the turn signal flasher fuse.
I CANT GET MY TURN SIGNAL OR 4WAY FLASHERS TO WORK ,FUELS ARE GOOD. I HAVE A 98 LINCOLN NAVIGATOR CANT GET THE TURN SIGNALS OR 4WAY FLASHERS TO WORK. FULSE OR GOOD
The Fiero has two flashers from the factory, the signal light flasher and the emergency or four way flasher. These are identical GM style two prong flashers. There are many quality levels and even a few novelty flashers available.