It's a switch, not a relay. And it's on the tranny. The reverse light relay is on the transmission, you have wiring from the transmission to a socket style clip, that wiring section is the relay for the reverse light.
The 1990 Jeep Cherokee electric fan relay switch is located on the firewall in the engine compartment. The fan relay switch will be on the passenger side of the firewall.
Start by removing the connections for the cruise control and brake lights, then remove the bolt that holds the switch to the brake pedal. Once the brake pedal is loose the switch is held on the brake pushrod by a bushing with nylon retaining washers. Carefully remove one washer and slide the bushing out, the switch can now be removed from the pushrod. Installation is the reverse; line up the hole on the switch with the hole on the pushrod, make sure the tabs for the cruise control and brake lights are facing properly. Reinstall the bushing and replace the other nylon washer, replace the bolt and tighten. Lastly connect the brake lights and cruise control.
It is usually located in the headlight switch. It is a automatic reset circuit breaker. When a short occurs it rapidly blinks the headlight circuit on and off so the headlights are not completely lost to allow you to pull off the road safely at night.
1990 will require an OBD1 reader
yes There was also a Laredo package for the XJ Cherokee in the 1990's.
Yes.
The backup light switch for the reverse lights on a 1990 Nissan 240SX is typically located on the transmission. It is mounted on the side of the transmission case, near the reverse gear. To access it, you may need to lift the vehicle and remove any obstructing components. Checking the vehicle's service manual can provide specific details on its exact position.
On a 1990 Chrysler LeBaron, the reverse light switch is typically located on the transmission. It is usually mounted on the side of the transmission case and is activated when the gear selector is moved into the reverse position. To access it, you may need to lift the vehicle and remove the necessary undercarriage components for better visibility. Always consult the vehicle's service manual for specific details and diagrams.
The 1990 Jeep Cherokee electric fan relay switch is located on the firewall in the engine compartment. The fan relay switch will be on the passenger side of the firewall.
The 1990 Jeep Cherokee electric fan relay switch is located on the firewall in the engine compartment. The fan relay switch will be on the passenger side of the firewall.
sounds like a problem with the grounding on switch
A 1990 Jeep Cherokee does not have a reset switch. The fuel system is computer controlled. If not functioning properly there could be a fuse or sensor malfunction.
switch is on the transmission
The backup light switch is located on the left side of the transmission. Disconnect the switch connectors, then unscrew the switch.
Begin by removing the retaining ring at the top of your 1990 Pontiac Bonneville ignition switch. The ignition switch will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.
The brake light switch is located on a bracket behind the brake pedal support.
check the fuse for the brake lights, they have thier own. also check the brake light switch at the at the top of the brake petal