Under the battery, on the battery tray.
Two sensors in the same part, yes.
A 1996 Jeep does not have a mass airflow sensor.
The plug or sensor above the oil filter on a 1996 Cherokee is the oil pressure sending unit. This sensor controls the oil pressure gauge.
p0141 is for the sensor behind the catalytic converter.
The PCM (engine computer) provides the power.
Two sensors in the same part, yes.
A 1996 Jeep does not have a mass airflow sensor.
location of relay for heated o2 sensor 1999 jeep Cherokee sport
On a 1996 Jeep Grand Cherokee with a 4.0-liter engine, the coolant temperature sensor is typically located on the engine block, near the thermostat housing. It is usually found on the driver's side of the engine, close to the cylinder head. You may need to remove any engine covers or components obstructing access to the sensor for visibility and removal.
The cam sensor is inside the distributor.
The cam sensor is inside the distributor under the rotor.
The plug or sensor above the oil filter on a 1996 Cherokee is the oil pressure sending unit. This sensor controls the oil pressure gauge.
It will bolt in, but the intake on the 1996 is different and the cylinder head on the 1996 does not have the temp sensor for the gauge in the same location.
No, it uses a MAP sensor (manifold absolute pressure)
The oil sensor is located above the oil filter next to the distributor.
It is in the distributor.
Map sensor voltage low.