If equipped, it is above the liftgate glass.
Check the fuse, bulbs/assy., and wiring another thing to check is where the bulbs connect. sometimes like my 94 one of the connectors in the bulb housing was broken. also there is a brake light sensor on the brake petal that is turned on when you depress the brake. usually near the top of the brake petal
I have a 95 cherokee. had lots of trouble with the coil blowing out till I ran a direct body ground to the coil mount. try changing the coil and running a ground wire from the frame or metal body direct to the coil mount. RW
if you mean how is it affixed/how to mount a new one - clean thoroughly, and use the same glue you'd use to mount a rear view to the inside fo the windsheild.
The question is not the biggest you can mount but should be the biggest you should mount. Original Equipment Size: 225/70-16 is the size tire you should use. Any other size will adversely effect handling, ride, mileage, and your odometer. You may be able to move up to a 235/60-16 tire and still have the same diameter tire. That depends on the brand tire you install. Talk to a trusted tire specialist for advice on any larger size than the OEM size.
Mercedes rims are 5 lug 5x112 and Jeep rims are 5 lug 5x5 (5x127). if you want to mount them you will need to buy adaptors.
most likely it is the high mount rear brake light. Open hatch and you will see where to remove the screw to access the bulb.
2
Remove the high mount brake light retaining screws from your Mazda Protg. Remove the high mount brake light wiring harness. Reverse the process to install your new high-mount brake light.
Remove the wiring harness from the high mount brake light. Remove the retaining screws. Reverse the process to install the new high mount brake light.
Remove the wiring harness from the high mount brake light. Remove the back cover of the brake light assembly. Take hold of the brake light connector, push in and turn at the same time. Reverse the process to install the new brake light.
Get a winch plate to mount to the bumper. Then mount the winch to the winch plate.
Center High Mount Stop Lamp or CHMSL. It is also called a third brake light.Center High Mount Stop Lamp or CHMSL. It is also called a third brake light.
Because you have a spoiler, Honda likely decided to not even include a light socket for the high mount brake light (behind rear window). It's because the spoiler fin blocks this high mount light anyways.Pop the trunk and check to see if a light bulb socket even exists for the high mount brake assembly. If a socket doesn't exist (and you don't see one hanging) then no worries, it was a Honda decision. This is the case for my 2000 Accord EX.
Not sure how to help, other than you will have to use bolts that fit.
The B.O.O. switch or Brake On/Off switch is located at the top of the brake pedal assemble.
take off tire then capiler then capiler mounting bolts theres 4 2 for each mount then harmmer rotor in center to break losse or rust the pop off
Just unscrew it.