answersLogoWhite

0

Sorry to tell you this - but - if it is the original equipment clock that was built with the car, the chances are 99% that the clock has burnt out. Those clocks were equipped with Liquid Crystal Diodes which have a finite life to them. If the clock is now dark, the odds are greatest that the clock has simply come to the end of its life and needs to be replaced.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How to reset clock on 2005 Honda Accord?

how do you reset the clock on a 2005 Honda accord how do you reset the clock on a 2005 Honda accord


How do you replace a clock spring on a 1995 Honda Civic?

how to replace a clock spring in a 95 honda civic ex


Where do you buy the clock light on a 2001 Honda accord?

Honda


How do you change the time on a Pontiac GTP Clock?

Push the buttons on the clock marked hours and minutes.


How do you replace bulb on 1998 Honda cr-v dash clock?

There is no bulb, the clock is actually an LCD. The clock will have to be replaced.


How do you change the clock light on your 2000 Honda CR-V?

The clock light is an integral part of the clock and is not replacable by itself


What would cause the clock light not to work on a 2002 Honda Accord SE?

The lightbulb for the clock is blown.


How do you change the clock light in a 1999 Cr-v Honda?

There is no back light for the clock. The clock numbers are actually LED's - there is no way to replace them - the entire clock will have to be replaced.


Honda CR-V how clock replacement?

If the clock is not working, it is most likely an internal problem with the clock itself. Check out the below site:


How to set clock on a 2002 Honda civic ex?

The clock on a 2002 Honda Civic can be reset in two ways. Removing the right tire will allow access to the clock controls. Our using the radio buttons to select the appropriate time.


Does 2001 Honda CR-V have clock fuse?

yes


How do you set the clock on a 2007 Honda jazz?

To set the clock on a 2007 Honda Jazz, start by turning the ignition switch to the "On" position without starting the engine. Press and hold the "Clock" button until the display begins to blink. Use the "H" and "M" buttons to adjust the hours and minutes, respectively. Once the correct time is displayed, press the "Clock" button again to set it.