0
Had the same problem. Looked up what the module was supposed to look like but could not find anything like it in the engine compartment. Looked it up in Haynes book and identified the wires. Ends up it was about the size and shape of your thumb and was wrapped up in the wire bundle just below the right hood hinge. Good luck.
What else can I help you with?
Wiring for 1996 Geo Metro diagram?
The wiring diagram on a 1996 Geo Metro is located inside the service manual. It details the location of each electronic component and how they are connected to each other.
Why did your radio just quit working on your 1999 Geo Metro?
Check for a blown fuse.
Which is the fuse for the radio and lighter in a 1996 Geo Metro?
Look under the dash between steering column and driver's side door, you may have to lay on your back to see under the dash and take a flashlight, the fuses are marked around the outside of the box to tell you what they are for, and under the hood up next to the firewall on the driver's side is another set of important fuses, different type than under the dash, but take a look, they are also marked as to what they control.
When was Nat Geo Music created?
Nat Geo Music was created in 2007.
What channel is NAT Geo on?
Nat Geo has its own channel.
Where is the transmission control module 1995 Geo Metro?
it is in the transmission
Where is the ignition control module located on a 1992 Geo Metro?
On a 1992 Geo Metro, the ignition control module is typically located on the driver's side of the engine compartment, mounted on or near the ignition coil. It can be found on the firewall or near the engine's intake manifold, depending on the specific engine configuration. For easier access, it may be necessary to remove some components surrounding the area. Always refer to the vehicle's service manual for the most accurate location and removal instructions.
What is the wheel lug bolt pattern for a 1992 geo metro?
the bolt patter for my 1992 geo metro on a 12" wheel is a 4x100
Can you use the hatchback from a 1992 Geo Metro to replace the hatchback on a 1994 Geo Metro?
it should be able to
Does a 1992 Geo Metro have an interference engine?
yes, if it's a 3 cylinder Mr Geo Metro yes, if it's a 3 cylinder Mr Geo Metro
Is there an air bag in a 1992 Geo Metro?
Yes, the 1992 Geo Metro does have one air bag. There is only an airbag for the driver and not the passenger side.
Where can you get a fuse diagram for a 1992 Geo Metro?
You can get a fuse diagram for a 1992 Geo Metro in the car's owner's manual. You can also check with different auto stores.
Where is the hood release on a 1992 Geo Metro?
The hood release on a 1992 Geo Metro is usually in the glove box. It is in the top left side inside the glove box.Ê
Can a 13 inch rim off a geo storm fit on a 1992 geo metro?
NO! Geo Storms have a 4X100mm bolt pattern, a Geo Metro has 4X114.3mm bolt pattern.
Where is the ECM located on a 1992 Geo Metro?
The Engine Control Module (ECM) on a 1992 Geo Metro is typically located under the dashboard on the driver's side, near the steering column. It may be secured to the vehicle's firewall or mounted on a bracket. To access it, you might need to remove some trim pieces or the cover under the steering wheel. Always consult the vehicle’s service manual for specific instructions and safety precautions.
Will a Geo Metro motor fit a 1992 geo storm?
sue in da house
Where is the tcm on a 1992 Geo Metro?
The Transmission Control Module (TCM) on a 1992 Geo Metro is typically located inside the vehicle, mounted under the dashboard near the driver's side. It may be found near the steering column or attached to the side of the center console. Accessing it usually requires removing some panels or covers for better visibility and reach. Always consult the vehicle's service manual for precise instructions and locations.
