The crank sensor is on the rear of the motor on the drivers side.It bolts to the bellhousing withe 2 bolts. It looks it has 2 wings on the sides where the bolts go through.It has a 2 wire plug going to it. Its easier to reach from the under side
The PCM (engine computer) provides the power.
yes
Top driver side of the bell housing.
Crank position sensor could be the problem. Worth looking into.
The crank sensor is located on the top of the bell housing on the drivers side.
probably crank sensor, they are famous for that
driver side on the back of the motor where is crak sensor on 94 jeep 4.0 grand Cherokee
You can not. The crankshaft position sensor is required to run the engine.
The ignition module uses the crank sensor to decide when to spark.
in a toilet
It has both.It has both.
It should be on or near the throttle body.
Below
The Jeep Grand Cherokee didn't exist until 1993.
The PCM (engine computer) provides the power.
Bad crank position sensor
the crank position sensor can cause similar symptoms jeep is known for crank sensor problems