answersLogoWhite

0

TTL is preferred in n-mos technology because it produces more heat and thus it's preferable in microcontroller circuit but c-mos does not produce waste heat which is why TTL is not preferred in c-mos.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How much does a Blackberry storm cost?

It cost at around $199.99 but if your a preffered customer than you might get a most preffered customer discount.


What is submicron cmos technology?

The sub-micron CMOS technology has channel length less than 1 micrometer


What is a CMOS processor?

CMOS is a type of material, not a specific type of processor. That is short for Complementary Metal Oxide Silicon. CMOS devices tend to use less power and tend to be faster than their older counterparts. So a CMOS processor is a processor made using the CMOS material. For instance the V20 chip is a 3rd party CMOS variation of Intel's 8088 CPU. The V20 is 10-20% faster and uses less power than the 8088.


Why you using micro controller NoT micro processor?

Microcontroller have inbuilt memory, interrupts, etc. Which you will need to connect externally in microprocessor. Thus, Microcontroller is better than microprocessors


Why is the chocolate ice cream is more preffered than strawberry ice cream?

it tastes better


Will msp430 microcontroller process more than 16 bit number?

Any microcontroller can handle numbers wider than the bus width of the micro (16 bits in the case of the msp430). It simply requires use of features such as the Carry bit in the Status register. A C-language compiler for the MSP430 will produce code to allow for processing of numbers larger than 16 bits. Use data type "Long" for a 32-bit integer.


Why you not use other than cmos?

Because ROMs are designed using MOS technology.


Why cmos is used more than other transistor?

Lower power dissipation (except at very very high switching rates, as almost all the power dissipated by CMOS is during switching).


Advantages of FPGA spartan over microcontroller?

FPGA Spartan is more efficient than the microcontroller. It is used to perform operations that cannot be properly done by microcontrollers; operations like high parallel or low latency operation.


What can be done to protect the CMOS Setup program from accidental change?

always ensure you have a healthy cmos battery as if it dies then all changes to the bios will usually be removed unless the motherboard has more than 1 battery


Why is CMOS better than single MOSFETs?

CMOS is better than single MOSFETs because the complementary MOSFETs in CMOS always have one off and the other on, reducing the idle current to only leakage current and the output voltage exactly equal that of either the power or ground as there is no voltage drop across the MOSFET that is on. With just one MOSFET the device draws current anytime it is in the on state, even if idle.


Why are pmos larger than nmos in cmos design?

PMOS transistors are typically larger than NMOS transistors in CMOS design because the mobility of holes (the charge carriers in PMOS) is lower than that of electrons (the charge carriers in NMOS). This means that a larger current-carrying area is needed in the PMOS to achieve the same performance as the NMOS transistor. By making the PMOS larger, designers can balance the drive strengths of the two types of transistors in a CMOS circuit.