answersLogoWhite

0

What else can I help you with?

Related Questions

What is the cause of the compressor if not trip to its overload?

What is the cause of a compressor if not trip to its overload


Can a breaker be bad and not trip when there is an electrical overload?

Yes, a breaker can be faulty and fail to trip when there is an electrical overload.


What is the difference between overload trip and over current trip. if there is an overload trip the current will be raised above the set point?

An overload trip is due to too much load on a circuit (for example, my wife running a hair dryer and portable heater on the same outlet). An over current trip is the same thing, but it can also refer to an actual fault condition where conductors have come in contact with eachother/shorted.


What caues LCD tv to trip off?

The power overload is what causes the LCD television to trip off.


What will cause a star delta panel to trip in delta?

On a star delta starter a motor overload or a motor going to ground and cause a short circuit will cause the overload protection to trip. These overloads have to be reset before the motor can be restarted.


Does mcb trip if a short circuit occurs?

Yes, a breaker will trip if there is a short circuit occurring on the breaker's connected load. The breaker will also trip on an overload condition when the current rises above the breakers trip set point.


What happens if you overload plug sockets?

the circuit breaker will trip or fuse will blow to open the circuit.


What is the definition of current trip overload or overloaad trip?

i think the meaning of that is a various types of time delay are used for overload trips to ensure that the generator breaks will not open due to a momentary current surge, but only if the excess current persist.....thats all.... :)


Why do circuit breakers trip?

Circuit breakers trip to protect the electrical system from overheating and potential fires caused by an overload of current flowing through the circuit.


How does a thermal overload control a circuit when the phase short to ground?

If you are describing a circuit breaker then its electromagnetic trip component will operate in the event of a line*-to-ground (*not 'phase'!) short circuit. The thermal overload component will only operate in the event of a sustained overload.


Why is there only allowed one skate profile?

because they dont want to overload it


How to trip a circuit breaker in case of an electrical overload?

To trip a circuit breaker in case of an electrical overload, locate the circuit breaker panel in your home, identify the breaker that corresponds to the overloaded circuit, and switch it to the "off" position. This will cut off power to the circuit and prevent further damage.