answersLogoWhite

0

Did you make sure the contact points in the remote for the batteries were making good contact? Try taking a pencil eraser and rubbing them to make sure you have a clean surface for your good batteries. Does it light up when you push the button? If not you probably have a connection inside the remote that has come undone. In this case, unless your an elelctronic's guru,....you will need to replace it. Also you may want to make sure there isn't a valet switch under the dash on the drivers side, usually near where the hood release is. If there isn't one you may need to ask the dealer to check that the transponder in the Jeep still works. it could be something as simple as a bad sensor or a blown fuse within the security system. Do the power locks work without the remote? if they don't, check your fuses.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What does Keyless entry FOB mean?

That's your remote control for unlocking / locking the doors etc ( key FOB )


What type of batteries does a rc remote control helicopter use?

RC remote control helicopter take AA batteries. On the average, I believe that they require about six batteries. What types of batteries is up to you.


How to program a keyless remote for a 2001 chevy camaro?

You can program a 2001 Chevrolet Camaro by locking then unlocking the door locks.


Why wont remote work on central locking 99 Ford Laser?

your batteries have run out of power


Can you recharge batteries for remote control cars?

Yes you can recharge batteries for remote control cars. Some remote control cars come with a rechargeable battery pack, while some you have to buy rechargeable AA's for them.


How can I reset a Fanimation remote control?

To reset a Fanimation remote control, you can usually remove the batteries, press and hold the power button for about 10 seconds, then reinsert the batteries. This should reset the remote control to its default settings.


After changing the batteries for the remote control how can you repogam it?

repogam?


What will stop a remote control from working?

Dead batteries.


Where can I get batteries for my Vizio remote control?

Your Vizio remote control needs AA batteries and these can be bought in your trusted supermarkets and hardware's. They may come in two's or four's in a pack.


Why would doors be locking and unlocking on your 97 Taurus it has no alarm or remote?

one of two reasons, someone is messing with you or you have a short (i.e. a wire that's split and arcs) in the wiring on your locking system.


How can I reset my ceiling fan remote control?

To reset your ceiling fan remote control, first turn off the power to the fan at the circuit breaker. Then, remove the batteries from the remote control. Press and hold the power button on the remote for 10 seconds. Reinsert the batteries and turn the power back on. Your remote control should now be reset.


What is the erls fuse for in a Pontiac Grand Am?

In a Pontiac Grand Am, the ERLS fuse is typically associated with the Electronic Remote Locking System. This fuse is responsible for powering the components related to the vehicle's remote locking and unlocking features, including the door locks and trunk release. If this fuse is blown, it may prevent the remote key fob from functioning properly, leading to issues with locking or unlocking the doors electronically. Always refer to the owner's manual for specific fuse information related to your vehicle's model year.