0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the fingering for high E flat on the trumpet?
On a standard Bb trumpet, the fingering for a bottom-line Eb is 12 and the fingering for all higher Ebs is 2.
What is the second fret of the bottom E called?
F# or F Sharp. You could also say Gb or G Flat
How do you plat D flat on tenor sax?
D flat is the same thing as C sarp, its the easiest ro describe how to play. Haha, you don't hold anything down, all your fingers are off the keys! :)
How many flats does the scale of E flat have?
No such major has b flat and e flat.
Does it matter which hi hat cymbal goes on the top or bottom?
Yes, in most cases it does matter. Usually the bottom hi-hat will be a little more flat. Sometimes depending on the model - it might even tell you which is which. Sometimes the bottom hi-hat has holes in it to allow air to escape.
Why tip of stalagmometer flattened?
When the force due to gravity on a drop, acting in the downward direction, becomes infinitesimally greater than the upward force of surface tension, the drop detaches from the stalagmometer and falls down.
What is a flat bottom drill?
A Forstner bit drills flat bottom holes.
What is flat bottom flask?
A flat bottom flask would be an Ehrlemeyer flask, which is used quite a lot by chemists.anf
What hull type if best used on ponds small lakes and calm rivers?
Flat Bottom Hull
Which of these hulls is planing hull round bottom flat bottom multi hull catamaran?
the flat bottom i think
What is a flat area on the ocean bottom?
An abyssal plain is a flat area on the ocean bottom
What can you say about flat tires?
They are only flat at the bottom.
How do you read a stalagmometer?
Use of the Stalagmometer allows for easy measurement of surface tension in solutions. The specified stalagmometer, 2.5 mL volumetric, is used to calculate the surface tension by measuring drop weight per volume of a sample in relation to a reference liquid. As a liquids drop weight is relatively proportional to its surface tension, the surface tension of a sample can be determined by comparison of the drop weight to that of a known reference liquid. This provides the formula: Surface Tension Measurement: 1. Remove a sample of solution from the bath and allow cooling to room temperature. 2. Position the stalagmometer on a pipette stand so that the sample solution can drip from the flat end of the instrument. 3. Using a pipette bulb, draw the cooled solution up past the top graduation mark on the stalagmometer. 4. Remove the pipette bulb and watch the bubble edge of the solution as it falls through the stalagmometer. 5. Begin counting the number of drops that fall from the end of the stalagmometer as soon as the edge of the bubble reaches the Start Mark on the stalagmometer. 6. Continue counting the drops until the bubble edge of the sample reaches the End Mark. Record the number of drops and repeat two more times. Average the three readings and record this as "N" 7. Calculate the surface tension as follows: Surface Tension = (14401) (D) (N) D = Density of Sample Solution (If unknown, use 1.25) N = Number of Sample Drops
Does a cylinder have flat face?
The top and bottom are normally flat.
What is a stalagmometer?
It's an instrument used to determine the number of drops in a given quantity of liquid.
How stalagmometer figure looks?
tell supose experiment ofsurface tension by drop method
What does the bass clef A flat key look like?
B flat on the second line on the bass clef, E flat on the third space from the bottom, A flat on the first space from the bottom and the D flat on the middle line.
