0
What else can I help you with?
Two chromatids of a chromosome are attached at a point called?
The chromatids of a chromosome are attached at a point called the centromere. The centromere is a region where the two chromatids are closely aligned and hold together until they separate during cell division.
What do you call the combination of solid liquid and gas?
This only occurs at a specific point on the phase diagram of a substance called the "triple point." This point corresponds to a certain pressure and temperature for an individual substance, since these are the axis values for a phase diagram.
What would be helpful to find the normal melting point and normal boiling point on a phase diagram?
Draw a vertical line through the triple point.
WHY is it placed on top of the building the ligthing rod?
Because lightning is always attracted to the highest points. Lightning rods are attached to long, insulated cables which lead down to the ground - and are anchored deep in the earth. Placing a lightning conductor at the very top of a building, almost guarantees that any strike will be conducted safely down to earth.
Why is a dot used in a free body diagram?
A dot is typically used to represent the center of mass of an object in a free body diagram. It simplifies the diagram and allows for clearer representation of the forces acting on the object at that point.
What direction do the arrows point in the diagram?
The arrows in the diagram point to the right.
Where is the anchor point for a throttle return spring in a 1997 Jeep Wrangler?
The plastic end slides on the steel grommet attached to the throttle lever. The spring end is anchored through a hole in the small bracket raised up and off the intake manifold.
Where does point gh intersects ab at point d?
In some diagram that is know to you but not to me.In some diagram that is know to you but not to me.In some diagram that is know to you but not to me.In some diagram that is know to you but not to me.
Where is the ground wire located on a Mercury villager?
In a Mercury Villager, the ground wire is typically located near the battery and is connected to the vehicle's chassis. It is often a thick, black wire attached to a designated grounding point on the frame or engine block. For specific locations, it's best to consult the vehicle's service manual or wiring diagram, as placement may vary slightly between model years.
A rock attached to a string swings in a vertical circle which free body diagram shows the forces on the rock at the highest point?
At the highest point of its swing, the string tension and the force of gravity acting downwards will be the only forces on the rock. The tension force will point downward and the gravitational force will point towards the center of the circle.
The equilibrium lines on a phase diagram meet at the what?
meet at the critical point on the diagram.
What is a suitable ground on a quad?
The frame is the best ground source on nearly all vehicles (assuming it uses a negative ground system, which is the most common type-negative post of battery is attached to the frame). If the frame can't be used, a metal part attached to the frame *may* be substituted, but always make sure to clean the attachment point to BARE metal, as paint or powder coating can act as an insulator, preventing a good ground connection.
What does a particular point of a line on a phase diagram represent?
The melting point or boiling point ...................
Wireless access point block diagram?
mesh sdr access point
Point on a chromosome where chromatids are attached?
Centromere
What is the point where pressure and temperature are just right for all three phases to exist at once on the phase diagram called?
This point is call the "triple point" and this is where all three lines meet together on the phase diagram.
Where is the ground cable wire on the chassis of a 2000 Chrysler lhs?
On a 2000 Chrysler LHS, the ground cable wire is typically attached to the chassis near the engine block or the battery. You can usually find it connected to a grounding point on the driver's side, often near the battery tray or the fender area. It is important to ensure that this connection is clean and secure for proper electrical grounding. If you're having trouble locating it, referring to a service manual or wiring diagram for your specific model can be helpful.
