No, a T100L 250V fuse cannot replace a T80mA 250V fuse. The "T" indicates that it is a time-delay (slow-blow) fuse, while the numbers represent the current rating; 100L means 100 mA, and 80mA means the original fuse is rated for a lower current. Using a fuse with a higher current rating can pose a risk of overheating or damage to the circuit, as it may not blow in a fault condition. Always replace fuses with the same specifications to ensure safety and proper functioning.
It should be the same thing. But other things are also described as T100L so you should make sure it's a fuse and check by holding it up to the light that it has a very thin wire inside the glass tube.
No
No, it is not recommended to replace a 250V 3.15A fuse with a 250V 2.5A fuse. The replacement fuse should have the same voltage rating, but the amperage rating needs to be equal to or higher than the original fuse to ensure proper protection against overcurrent.
nope
No, it is not safe to replace a 250V 10A fuse with a 125V 15A fuse. The voltage rating of the fuse must be equal to or greater than the system voltage, and the amperage rating must be equal to or lower than the rated current of the circuit. Using a lower voltage or higher amperage fuse can lead to safety hazards, including potential fire risks.
It should be the same thing. But other things are also described as T100L so you should make sure it's a fuse and check by holding it up to the light that it has a very thin wire inside the glass tube.
No
No, it is not recommended to replace a 250V 3.15A fuse with a 250V 2.5A fuse. The replacement fuse should have the same voltage rating, but the amperage rating needs to be equal to or higher than the original fuse to ensure proper protection against overcurrent.
Yes, you can use a 250V 3A fuse to replace a 250V 3.15A fuse, but it's important to consider the application. The 3A fuse will blow at a lower current than the 3.15A fuse, which may lead to nuisance blowing if the circuit regularly draws close to or slightly above 3A. Ensure that the device or circuit does not exceed the lower rating of the 3A fuse during normal operation to avoid interruptions.
Yes, a 250V fuse can replace a 125V fuse if they have the same ampacity rating. The voltage rating is simply the maximum voltage that the fuse is capable of safely interrupting. You can go higher, but you can not go lower. Obviously, the form factor of the fuse must be the same, but that is often the case.
nope
yes. the 250v just means that's the maximum voltage rating the fuse can handle .. so it can def handle 125v. just not vice versa.
No, it is not safe to replace a 250V 10A fuse with a 125V 15A fuse. The voltage rating of the fuse must be equal to or greater than the system voltage, and the amperage rating must be equal to or lower than the rated current of the circuit. Using a lower voltage or higher amperage fuse can lead to safety hazards, including potential fire risks.
The current rating is 2A (2 amps).
yes it can but it may not protect as well the f5L is a fast blow fuse made to react quickly to the overcurent
T= timedelay 800= ? L=? 250V= volts
In most cases yes. but it depends on the application. The L in that model of fuse pertains to its ability to withstand destructive forces when it blows out.