That depends on 1) what indoor coil you have, 2) is the ductwork adequate to support 4 tons and 3) if the indoor coil and ductwork are suitable does the blower have the capacity to support 4 tons or 1600 cfm? If so it must be sped up.
There are 2,000 pounds in a ton. Therefore, half a ton is equal to 1,000 pounds. By multiplying 1,000 by 4, you would get 4,000 pounds in 4 and a half tons.
500 lbs is 1/4 of a ton. (A ton is 2000 lbs.)
1/4 (0.25) of long ton (2240 lbs) in ounces = 0.25 * 2240 * 16 = 8960 ounces>1/4 (0.25) of short ton (2000 lbs) in ounces = 0.25 * 2000 * 16 = 8000 ounces
4 goes into 140 35 times. 140/4 = 35
How many pounds is a quarter of a ton you ask well the answer is 500 because when you do the math first you get 80 then 500 then 2000 so in that case the middle number will be you answer 500 is the answer.
You have to replace the condenser too.You need a bigger condenser to discard the heat from your space that the bigger compressor sucks. Andreas Petrides from Cyprus
Replacing a 2-ton condenser with a 4-ton condenser is generally not advisable, as it can lead to inefficiencies and potential issues. A larger unit may cool the space too quickly, causing short cycling and increased wear on the system, while also failing to properly dehumidify the air. It's important to size the HVAC system according to the specific cooling load of the space, which should be determined by a professional assessment. Always consult with an HVAC technician before making such changes to ensure optimal performance and comfort.
4
No. It will be less efficient.
Yes, a 4-ton outside condenser unit can work with a 5-ton inside air handler, but it may not operate efficiently. The condenser's capacity is lower than the air handler's, which could lead to undercooling or insufficient dehumidification. It's generally best to match the capacities of the condenser and air handler for optimal performance and efficiency. Consulting an HVAC professional for proper sizing and compatibility is recommended.
You can't match an air handler to an air handler. I assume you meant a 3.5 Ton A/H to a 4 Ton condenser. The answer is no. If the A/H was 4 Ton & you had a 3.5 Ton condenser you could with an expansion valve setup. You should really match equipment when possible & I highly recommend using a qualified technician.
yes it can. you can you can only downsize a coil by .5 tons or up .the flowrator piston have to be be changed according the the condenser size don't ever try to go more than1/2 ton it would damage the system.
yes it can. you can you can only downsize a coil by .5 tons or up .the flowrator piston have to be be changed according the the condenser size don't ever try to go more than1/2 ton it would damage the system.
Yes, a 4-ton condenser can work with a 5-ton air handler, but it may not operate efficiently. The mismatch can lead to inadequate cooling or heating, as the air handler may not be able to effectively utilize the cooling capacity of the smaller condenser. It's essential to ensure the system is properly balanced to optimize performance and energy efficiency. Consulting with an HVAC professional is recommended to evaluate compatibility and make necessary adjustments.
4 ton
A 2-ton air conditioner typically contains around 4-5 pounds of R22 refrigerant.
It is a 4 ton ten seer a/c condenser