0
I changed my downstream sensor by driving the car, 2000 Alero, onto ramps then I set the emergency break. I disconnected the battery to reset the computer before I removed the sensor. The sensor on this car was located on a short pipe between the converter and the muffler. I guess that there is a special socket to remove the sensor but I just grabbed the nut of the sensor with a pipe wrench, since I was replacing the sensor anyway. With the extra pulling power of the big wrench the sensor screwed right off. I carefully pulled the cable of the sensor away from the clips all the way up to the connector. The connector had a safety clip which pulled out, then the electrical connector is pulled apart by bending down the plastic side clip of the bottom connector. I replaced the new sensor using care not to break the wires. Then I worked backwards replacing the cable the same way that I removed the old one.
What else can I help you with?
Which is larger 0013 or 02?
.02 is larger than .0013 (13 is larger than 2 if they are not decimals)
What element detects change in a control system?
Receptor/Sensor-Recognition of the factor.
How do you change the water temp sender?
To change the water temperature sender, locate the sensor usually near the engine block or thermostat housing. Disconnect the electrical connector, use a wrench or socket to remove the sensor, then replace it with a new one and reconnect the electrical connector. Make sure to use thread sealant on the sensor threads to prevent leaks.
Where is the 02 sensor heater circuit bank 2 sensor 2 located on the 2002 Toyota Tundra?
There are 2 catalytic converters on a V8 2002 Toyota Tundra. Bank 1 is the manifold and cat on the drivers side and bank 2 is the manifold and cat on the passenger side. Sensor 1 is the sensor on the exhaust manifold before the catalytic converter. Sensor 2 is the sensor located after the cat converter. Bank 2 Sensor 2 is the sensor located after the catalytic coverter on the passenger side.
How do you change the o2 sensor in a Volvo 240 dl?
Wait until the car is cooled down. To change an o2 sensor you must have an 7/8 inch wrench or have an o2 sensor wrench. After finding the correct tool for the application you then jack up the car in most cases. Find The o2 sensor in the exhaust system most likely at the front of the car behind the front wheels about 2 feet in. Loosen the o2 sensor with the wrench and unscrew. Reverse process for installation.
Could an oil change cause an 02 sensor to malfunction in a 1996 Honda civic?
NO.An oil change will not harm the sensor.
What does PO135 mean when checking the codes?
02 sensor heater curcuit malfunction (bank 1 sensor1)---change front 02 sensor if need be.
Where is the EGR sensor on 1999 Ford Escort?
It doesn't have it's own sensor. It recirculates exhaust gas according to the engine temperature and 02 sensor.
Will the o2 sensor reset it self in a 96 ford explorer if you change it or do you have to do it with the computer?
there is no need to reset the computer for an 02 sensor.
How do you change the oxygen sensor on a 1997 Jeep Wrangler?
Use a 02 socket. The 2 sensor are located in front and behind the cat.
How much does it cost to change o2 sensor on lancer?
the price of the 02 sensor. under 20 bucks. and about 10 min of your time.
How do you change o2 sensor on Monte Carlo?
Depending on the year of the Monte Carlo the 02 sensor could be installed in several places on the exhaust. The 02 sensor screws in. You may need a special socket to remove it, just unscrew the sensor and screw the new one in.
Were is the secondary 02 sensor located?
where is the secondary 02 sensor on a 2004 crv
Will there be any change in performance if the exhaust 02 sensor is disconnected?
Yes, performance and fuel economy will suffer.
How do you change the 02 sensor in a 1997 Ford Expedition?
unplug it from wiring harness and unscrew the o2 sensor from the exhaust pipes, and reverse the process with the new one
What makes an 02 sensor go bad?
exaust leaks , faster if its before the 02 sensor
What is a code p0139?
P0139 02 Sensor Circuit Slow Response (Bank 1 Sensor 2)P0139 02 Sensor Circuit Slow Response (Bank 1 Sensor 2)
